User manual SONY UP-CR10L

[. . . ] editing the image, touch 8 After verifying the number of . prints and the price, touch 9 Ask the store clerk to enter the password. * Printing begins! CompactFlash card Microdrive SmartMedia card Do not remove your memory card until a message appears asking you to do so. Caution Before using a memory card, be sure to create a backup copy of its contents. [. . . ] Fingerprints and other pollutants can lead to reduced print quality. Replacing the Paper Roll 1 Open the front door. 2 Press the paper holder release button, and remove the paper holder. 3 Open the paper holder completely by pressing the button at the top. 4 Remove the paper roll from the paper holder. 5 Pull the paper core out of the old paper roll. Clear out any paper scraps that have built up in the paper holder. 6 Insert the paper core into the new paper roll. 7 Insert the paper roll into the paper holder with the arrow on the label pointing inward, and then remove the label. 8 Close the paper holder. 9 Insert the paper holder into the printer. 10 Close the front door. to * Make sureroll. fully remove all labels from the paper Troubleshooting Symptom Cause / Remedy Image data cannot be read. A mounted memory card does not contain any data. tInsert a memory card that contains image data. Data has been recorded on a memory card in a format that the unit does not recognize. t Be sure to store image data in a format that the unit can recognize. The memory card may not be properly inserted. tMake sure that the memory card is fully inserted. The memory card may not be inserted in the correct direction. tSet the memory card in the direction shown on the operation screen. Depending on the display angle, the display may not be visible or may be difficult to see. Adjust the angle of the display to improve the display appearance. tAdjust the print position on the administration screen. Paper roll may not have been loaded correctly. [. . . ] Are you trying to load 2UPC-C13, C15 while adaptors are mounted in the paper holder?tRemove the adaptors and then load the paper roll. Display not on or difficult to see. There is a white margin on the printed image. Paper roll was loaded, but "no paper" message appears. [. . . ]