User manual SONY V7400

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ­ Increase the separation between the equipment and receiver. [. . . ] The cooling fan on your Home Server is not working. Check the exhaust air vent on the back (page 12) for any obstacles. There already is a Data Sync (transmitting) profile on the destination device. Use the specified folder on the destination device or delete the profile to add a new one. A session to create a new profile for the Remote Home Access functions failed. A session to change a Data Sync (transmitting) profile timed out. A new file was created or an existing file was updated on your Home Server by the Data Sync (receiving) function. This message will automatically disappear in 24 hours. Device registration for the Remote Home Access functions failed. Data import with the One Touch Copy function failed. Check your data for corruption. Cannot create Data Sync receive folder Press OK Cooling Fan failure Data Sync device already registered Press OK Data Sync setup failed Press OK Data Sync setup timed out Press OK Data Sync Updated Defective USB device connected Device registration failed. An attempt to start a new process was made while another process is in progress. Wait until the on-going process completes. Troubleshooting Hard drive needs formatting In progress Please wait 63 Error message LAN cable not connected Nothing to copy. Press OK Causes/measures The network cable is not properly connected. Refer to the Setup Guide and see "Connecting to a network. " There are no files to be imported with the One Touch Copy function on the connected device. Capture new photos or videos first and then use the One Touch Copy function. You might have pressed the COPY button without connecting a copy source device. Access the Home Server Settings Page and update your Home Server (page 52). Check the Home Server Settings Page (page 20) for the message. A confirmation code was not obtained during the course of creating a Data Sync (transmitting) profile. Check your Home Server for Internet access (page 42). A permission code was not obtained during the course of creating a Data Sync (transmitting) profile. [. . . ] (But if you find any bugs, please let us know!) 2. You can use this software for whatever you want. You may not pretend that you wrote this software. If you use it in a program, you must acknowledge somewhere in your documentation that you've used the IJG code. In legalese: The authors make NO WARRANTY or representation, either express or implied, with respect to this software, its quality, accuracy, merchantability, or fitness for a particular purpose. [. . . ]