User manual SONY VCT-55LH

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. [. . . ] Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. This tripod's one pan handle provides both pan lock and tilt lock. fastening the pan handle lightly enables tilt lock , and fastening it tighter enables pan lock. Before panning and tilting, make sure that the elevator lock knob is locked firmly. This tripod has two separate elevators for low position work. The legs are not strong enough when extended. Tribod (1), Carrying case (1), Set of printed documentation Design and specifications are subject to change without notice. Pin Camera mounting shoe Tripod head Main unit Straddle adjustment knob Elevator lock knob Elevator B Leg Elevator stopper Camera mounting screw and knob Camera mounting shoe lock lever Tripod head lock knob Elevator A Pan handle Leg length adjustment lock lever Lock the leg length adjustment lock levers. Spread the legs until the tripod becomes stable. Spread the tripod legs slowly and carefully. Pulling them apart forcefully may cause damage. Install the battery pack, "Memory Stick" and a cassette in the digital still camera/video camera before mounting to the tripod. While pulling the camera mounting shoe lock lever fully to "FREE", slide out the camera mounting shoe from the tripod head. [. . . ] Install the battery pack, "Memory Stick" and a cassette in the digital still camera/video camera before mounting to the tripod. While pulling the camera mounting shoe lock lever fully to "FREE", slide out the camera mounting shoe from the tripod head. When you attach the video camera, align the pin with the positioning hole. [. . . ]