User manual SONY VCT-SP1BP

[. . . ] You will hear a click as the camera is attached to the monopod. Push the camera mounting shoe lock lever to the right to lock the camera in place. 4 Connect the remote plug to the LANC connector of the video camera. If the remote commander cord is too long, fasten the cord to the shaft with a cord belt. [. . . ] If the video camera is not properly attached to the monopod and falls off, it could cause an injury to you or the other person or cause damage. Also make sure that you do not hit a person or an object when you carry the monopod with the video camera attached. On some video cameras, you may be able to change the zooming speed by using the zoom speed switch and according to the tilt angle of the zoom lever. Press down the counter balance switch lever to the left and set the camera mounting shoe in a slant. adjust the position so that the BALANCE mark is aligned with the upper side mark. After pressing down the counter balance switch lever to the right, slide the monopod head slightly until it clicks and is fixed. Confirm that the tilt spring is working and then tighten the tilt lock lever. 2 Confirm that the monopod is set at the shortest length and the leg length adjustment lock lever is tightened. 3 While holding down the safety lock lever, pull the camera mounting shoe lock lever to the left to detach the camera mounting shoe. 4 Place the monopod in a safe location after you have prepared it. (4 speed settings) Zooming is performed at a faster speed according to the tilt angle of zoom lever. Printed on 70% or more recycled paper using VOC (Volatile Organic Compound)-free vegetable oil based ink. This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable take-back scheme for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. the recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Sony office or visit Sony Europe's web site for business customers: http://www. Net/environment This product with the CE marking complies with the EMC Directive issued by the Commission of the European Community. Compliance with this directive implies conformity to the following European standards: · eN55103-1 :Electromagnetic Interference (Emission) · EN55103-2 :Electromagnetic Susceptibility (Immunity) This product is intended for use in the following Electromagnetic Environment(s): E1 (residential), E2 (commercial and light industrial), E3 (urban outdoors) and E4 (controlled EMC environment ex. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 Pin Camera mounting shoe Monopod head Tilt lock lever Camera mounting screw Safety lock lever Camera mounting shoe lock lever Counter balance switch lever Hook holder Remote cord Cord belt FOCUS button REC REVIEW button REC START/STOP button Zoom lever Zoom direction switch Zoom speed switch Remote plug Leg Leg length adjustment lock lever Clamp lever Remote plug holder Remote cord holder Clamp Shoulder belt Support belt Adjuster Waist belt Hook Monopod holder Buckle D-ring 6 Check the scene when you stop the tape. press the REC REVIEW button in the standby mode. The last portion where you stopped recording will be played back on the liquid crystal display of your video camera for several seconds, and then the camera is returned to standby mode. [. . . ] If you use too much force, the plug could be damaged. Fix your video camera by firmly tightening the tilt lock lever. Do not attach accessories to the video camera after mounting it on the monopod head. Otherwise, the monopod head could tilt and damage the video camera. [. . . ]