User manual SONY VG-B50AM

[. . . ] When attaching a battery pack, attach it to either side. Do not touch the terminal of the battery pack tray . Check that the battery pack is firmly attached on the battery pack tray. ) If the battery pack tray is inserted incorrectly, you cannot push up the battery stopper with your finger. [. . . ] The model and serial numbers are located inside of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. The operations of the unit's dials and buttons are same as those for the camera main body. Leaving the battery packs inserted in the unit may cause the battery chamber to be damaged because liquid can leak from a battery. If that should occur, take the unit immediately to the nearest Sony dealer for repair. Be sure to use a genuine Sony battery pack with this unit. This unit does not have a battery charger function. When using this unit attached to the camera with the 70-200mm F2. When using this unit attached to the camera with 70-200mm F2. 8 G lens attached to the tripod-mounting collar, the following lens switches may not operate at the vertical shooting. Before vertical shooting, set them at the horizontal position. Focus-mode switch DMF-mode switch Focus-range limiter When using a tripod, use one screw that is 5. This unit cannot be firmly fastened on a tripod using long screws. Places to avoid for unit use and storage Regardless of whether this unit is in use or in storage, do not leave it where it can be exposed to: Extremely high temperatures Do not leave this unit where it might be exposed to direct sunlight; Avoid places like vehicle dashboards or near heat sources. [. . . ] When dirty, this unit may be cleaned with a clean, dry cloth. Do not allow this unit to come in contact with alcohol or other chemicals. This unit has an electrically-connected signal contact point with the camera. If you load the battery pack(s) while this unit is not attached to the camera, the unit could malfunction or be damaged by a shorting of the contact point. [. . . ]