User manual SONY VG-CRB10

[. . . ] To reduce fire or shock hazard, do not expose the unit to rain or moisture. Tape over lithium battery contacts to avoid short-circuit when disposing of batteries, and follow local regulations for battery disposal. Keep batteries or things that could be swallowed away from young children. When attaching a battery pack, attach it to either side. [. . . ] Make sure that the battery pack stopper locks the battery pack tray. Printed on 70% or more rectcled paper using VOC (Volatile Organic Compound) -free vegetable oil based ink. Immediately remove the batteries and discontinue use if. The product is dropped or subjected to an impact in which the interior is exposed. The product emits a strange smell, heat, or smoke. Electric shock may occur if a high voltage circuit inside the product is touched. The operations of the unit's dials and buttons are same as those for the camera main body. When using this unit in vertical orientation, set the grip control ON/OFF switch to "ON. Switch the power ON and OFF with the POWER switch of the camera. The grip control ON/OFF switch can not switch the power ON and OFF. Do not expose the batteries to excessive heat such as sunshine, fire or the like. This unit cannot be firmly fastened on a tripod using long screws. This unit is designed to be dust-and moisture-resistant but not to be waterproof and splash-proof. Only one or two "InfoLITHIUM" battery pack(s) NP-FM500H can be used. nP-FM55H , NP-FM50 , NP-FM30 cannot be used. Remove the battery packs when storing this unit for an extended period of time. Leaving the battery packs inserted in the unit may cause the battery chamber to be damaged because liquid can leak from a battery. If that should occur, take the unit immediately to the nearest Sony dealer for repair. Be sure to use a genuine Sony battery pack with this unit. This unit does not have a battery charger function. Symptom Remedy The camera does not work even after the Check that the unit attachment screw is securely tightened. Unit is attached to the camera, the battery pack(s) are inserted into the unit and the Check that the battery pack(s) are camera POWER switch is set to ON. [. . . ] Excessive vibrations Strong electromagnetism or rays Excessive sand or dust This unit is designed for use from 0 °C to 40 °C (32 °F to 104 °F). a rapid and dramatic rise in temperature causes condensation to form. Therefore, seal the unit in a plastic bag and remove as much of the air inside of the bag as you can before attempting to bring this unit inside after being in the cold for any extended period of time. Once the temperature in the bag has had a change to rise gradually to the temperature in the room, you can safely remove it from the bag. [. . . ]