User manual SONY VG-CV520G WMAT

[. . . ] Make sure that the battery pack stopper locks the battery pack tray. The operations of the unit's dials and buttons are same as those for the camera main body. When using this unit in vertical orientation, set the grip control ON/OFF switch to "ON. Switch the power ON and OFF with the POWER switch of the camera. [. . . ] By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. the recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. When inserting the two battery packs, the following indicator will be displayed on the LCD screen of the camera. Printed on 70% or more rectcled paper using VOC (Volatile Organic Compound) -free vegetable oil based ink. For any service or guarantee matters please refer to the addresses given in separate service or guarantee documents. Of the two battery packs, use the one that has less power first. When doing so, the mark of the battery pack in use is bright and the mark of the other battery pack is dark. The remaining battery level of the battery pack in use is displayed as a percentage (%). The mark of the battery pack in use changes as shown below. When the power of battery in use runs out, the unit automatically switches to the other battery pack. The unit can become deformed or experience malfunctions if left inside a vehicle. This unit is designed for use from 0 °C to 40 °C (32 °F to 104 °F). a rapid and dramatic rise in temperature causes condensation to form. Therefore, seal the unit in a plastic bag and remove as much of the air inside of the bag as you can before attempting to bring this unit inside after being in the cold for any extended period of time. Once the temperature in the bag has had a change to rise gradually to the temperature in the room, you can safely remove it from the bag. These procedures will prevent the unit from changing temperatures rapidly, and therefore prevent condensation from forming. When dirty, this unit may be cleaned with a clean, dry cloth. Do not allow this unit to come in contact with alcohol or other chemicals. This unit has an electrically-connected signal contact point with the camera. If you load the battery pack(s) while this unit is not attached to the camera, the unit could malfunction or be damaged by a shorting of the contact point. When attaching this unit to the camera, detaching this unit from the camera or storing this unit separately, be sure to remove the battery pack(s) from this unit. [. . . ] 1 oz) (including the battery tray, excluding the battery packs) Operating temperature 0°C to 40°C (32°F to 104°F) Included items Vertical grip (1), Battery tray (1), Terminal cover (1), Set of printed documentation Design and specifications are subject to change without notice. 1 2 3 4 5 6 7 Electrical contacts Guide bar Attachment screw Locating pin Battery chamber OPEN/CLOSE knob Recording: Fn button Playback: (Rotate) button Recording: C (Custom) button Playback: (Histogram) button Multi selector Rear control dial Grip control ON/OFF switch (Exposure) button Recording: AF/MF (Auto focus/Manual focus) button Playback: (Close focus) button Recording: AEL (AE lock) button Playback: (Index) button Camera battery cover slot Strap hook Shutter button Front control dial Tripod receptacle Battery pack stopper Battery pack tray If the battery pack(s) is in this unit, remove the battery pack(s) from this unit. 3 Remove the terminal cover of this unit's electrical contacts. After use, put the terminal cover back on to protect the electrical contacts. [. . . ]