User manual SONY VAIO VGN-CR410E/P

[. . . ] Then screw it down with the supplied screw 8. On the other side of the mounting surface to cover the protruding tips of the screw so they will not interfere with any electrical cables etc. The numbers in the list are keyed to those in the instructions. After installing the steering wheel column cover, attach the rotary commander to the mounting hardware by aligning the four holes on the bottom of the rotary commander with the four catches on the mounting hardware and sliding the rotary commander until it locks into place as illustrated. [. . . ] Handle the bracket carefully to avoid injuring your fingers. Do not tamper with the four holes on the upper surface of the unit. They are used for tuner adjustments to be made only by service technicians. Choose the installation location carefully so that the unit will not interfere with normal driving operations. Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperatures, such as in direct sunlight or near heater ducts. Use only the supplied mounting hardware for a safe and secure installation. How to detach and attach the front panel Before installing the unit, detach the front panel. Before detaching the front panel, be sure to press (OFF) first. Then press (OPEN) to open the front panel, then slide the front panel to the right side, and pull out the left side of the front panel. Place the hole a in the front panel onto the spindle b on the unit as illustrated, then push the left side in. When the installation and connections are complete, be sure to press the reset button with a ballpoint pen etc. For connecting two or more changers, the source selector XA-C30 (optional) and the BUS cable RC-61 (1 m) or RC-62 (2 m) (optional) are necessary. Be sure to connect the earth cord before connecting the amplifier. If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated. >`n , , Supplied with XA-C30 Suministrado con el XA-C30 " ­a' XA-C30 After connecting, bundle up the connecting cord of the rotary commander with other connecting cords of the audio equipment by attaching the supplied cramper 0. Be sure to leave some slack in the connecting cord between the plug and the cramper. Connecting any other system may damage the unit. 'oe«H, , , to power antenna control lead or power supply lead of antenna booster amplifier <Note> In case of without power antenna, or antenna booster, not necessary to connect this lead. To the +12 V power terminal which is energized in the accessory position of the ignition key switch Be sure to connect the black earth lead to it first. " /l ¨-->"¥ ­N¶´ ­ a u»P¤ s­ ¡C to the +12 V power terminal which is energized at all times Be sure to connect the black earth lead to it first. [. . . ] " /l ¨-->"¥ ­N¶´ ­ a u»P¤ s­ ¡C to the +12 V power terminal which is energized at all times Be sure to connect the black earth lead to it first. To a metal point of the car First connect the black earth lead, then connect the yellow and red power input leads. Note on the control leads The power antenna control lead (blue) supplies +12 V DC when you turn on the tuner. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition key is turned off. [. . . ]