User manual SONY VAIO VGN-CR508E/L HARD DISK DRIVE REPLACEMENT INSTRUCTIONS

[. . . ] For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. Applicable accessories: Remote commander Disposal of waste batteries (applicable in the European Union and other European countries with separate collection systems) A DualDisc is a two sided disc product which mates DVD recorded material on one side with digital audio material on the other side. However, since the audio material side does not conform to the Compact Disc (CD) standard, playback on this product is not guaranteed. Basic Operations Notes If your country or region does not support DAB broadcast, "NO SERV" appears. Do not press any button on the unit or the remote during DAB Automatic Scan. [. . . ] If you do not use the remote for a long period of time, remove the batteries to avoid damage from battery leakage and corrosion. 3 Start playback. Press (play) (or CD/ (play/pause) on the unit) . To Pause playback Press Use buttons on the unit to play a tape. 1 Select the tape function. Press FUNCTION repeatedly. 2 Insert a tape. Press (stop/eject) , and insert the tape into the cassette holder. Make sure there is no slack in the tape to avoid damaging the tape or the tape deck. To set the clock Use buttons on the remote to set the clock. 1 Turn on the system. Press (on/standby) . (pause) (or CD/ on the unit) . / (go back/go forward) (/ on the unit) . Hold down / (rewind/ fast forward) during playback, and release it at the desired point. REPEAT repeatedly until "REP" or "REP1" appears. Stop playback Select a folder on an MP3 disc Select a track or file Find a point in a track or file Select Repeat Play 3 Start playback. Press (play) . To Pause playback Press 2 Select the clock set mode. Press CLOCK/TIMER SET . If the current mode appears, press / repeatedly to select "CLOCK, " and then press ENTER . (pause) . / (rewind/fast forward) . 3 Set the time. Stop playback Rewind or fast forward* Speakers Insert only the stripped portion of the cord. Speaker cord (Red/) Left speaker Right speaker Speaker cord (Black/) Press / repeatedly to set the hour, and then press ENTER . Use the same procedure to set the minutes. The clock settings are lost when you disconnect the power cord or if a power failure occurs. * Be sure to press (stop/eject) after the tape has been wound or rewound to the end. To run the DAB Automatic Scan When you turn on the system for the first time after you purchase the system, DAB Automatic Scan starts automatically and creates a list of available services. If you want to run the DAB Automatic Scan again, perform the procedure below. Press PLAY MODE repeatedly while the player is stopped. Do not clean discs with solvents, such as benzine thinner, or commercially available cleaners or anti-static spray intended for vinyl LPs. Do not expose discs to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight. CDplayersection On safety General The system unexpectedly shuts off while operating. Are the + and speaker cords short-circuited?Make sure the speaker cords are correctly connected. 4 Press ENTER to add the track or file to the program. 3 Start recording. Press (record) , and then start playing the desired recording source. If there is noise while recording from the tuner, reposition the appropriate antenna to reduce the noise. While recording, you cannot listen to other sources. To stop recording, press . Tip We recommend that you press first, and then press to avoid noise being recorded when you stop recording. 5 Repeat steps 3 through 4 to program additional tracks or files, up to a total of 15 tracks or files. There is no sound. 6 To play your program of tracks or files, press . The program remains available until you open the CD compartment. To play it again, select the CD function, and then press . To cancel Program Play, press PLAY MODE repeatedly until "PGM" disappears while the player is stopped. To delete the last track or file of the program, press CLEAR while the player is stopped. To view program information, such as total track number of the program, press DISPLAY repeatedly. Are the + and speaker cords short-circuited? The specified station may have temporarily stopped broadcast. The unit is not disconnected from the mains as long as it is connected to the AC outlet, even if the unit itself has been turned off. [. . . ] 3 Press / repeatedly to select "PLAY SET, " 4 Set the time to start playing. Press / repeatedly to set the hour, and then press ENTER . Use the procedure above to set the minutes. Return to Normal Play by pressing PLAY MODE repeatedly until both "PGM" and "SHUF" disappear. and then press ENTER . "ON TIME" appears, and the hour indication flashes. Starting playback takes more time than usual. Clean this system with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as thinner, benzine, or alcohol. 6 To call up a preset radio station, press TUNING MODE repeatedly until "PRESET" appears, and then press +/ repeatedly to select the desired preset number. The following discs take a longer time to start playback. [. . . ]