User manual SONY VAIO VGN-CR508E/R HARD DISK DRIVE REPLACEMENT INSTRUCTIONS

[. . . ] Should you notice an abnormality in the unit, disconnect the main plug from the AC outlet immediately. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Do not expose batteries or apparatus with battery-installed to excessive heat such as sunshine, fire or the like. Notice for the customer in the countries applying EU Directives. The manufacturer of this product is Sony Corporation, 1-7-1 Konan Minato-ku, Tokyo, 108-0075 Japan. [. . . ] The preset stations are retained for about half a day even if you disconnect the power cord or if a power failure occurs. 6 1 2 Tune in the desired station (see "Listening to the radio" (page 13)). Press TUNER MEMORY . To call up a preset radio station, press TUNING MODE repeatedly until "PRESET" appears, and then press +/ repeatedly to select the desired preset number. 3 Preset number Press +/ repeatedly to select your desired preset number. If another station is already assigned to the selected preset number, the station is replaced by the new stations. 4 Press ENTER . 0GB Using the Timers The system offers two timer functions. If you use the Play Timer with the Sleep Timer, the Sleep Timer has priority. SleepTimer: You can fall asleep to music. This function works even if the clock is not set. 4 Set the time to start playing. Press / repeatedly to set the hour, and then press ENTER . Use the procedure above to set the minutes. 5 6 Use the same procedure as in step 4 to set the time to stop playing. Other Operations Press SLEEP repeatedly. If you select "AUTO, " the system automatically turns off after the current disc, tape or USB device stops or in 100 minutes. If the tape deck is still playing or recording at the set time, the system turns off after the tape deck stops. PlayTimer: You can wake up to CD, tuner or optional USB device at a preset time. Use buttons on the remote to control the Play Timer. Make sure you have set the clock. Select the sound source. Move the speakers away from the system, or place them on separate stands. At high volume, speaker vibration may cause the sound to skip. Press PLAY MODE repeatedly until both "PGM" and "SHUF" disappear to return to normal play. General Soundcomesfromonechannel, ortheleftandrightvolumesare unbalanced. Place the speakers as symmetrically as possible. Connect only the supplied speakers. GB Startingplaybacktakesmoretime thanusual. The following discs take a longer time to start playback. a disc recorded with a complicated tree structure. a disc that has not been finalized (a disc to which data can be added). a disc that has many folders. "OVERCURRENT"appears. A problem has been detected with the level of electrical current from the (USB) port . Turn off the system and remove the USB device from the (USB) port . [. . . ] In this situation, remove the disc, and leave the system turned on for about an hour until the moisture evaporates. Onheatbuildup Heat buildup on the unit during operation is normal and is not cause for alarm. Do not touch the cabinet if it has been used continuously at a high volume because the cabinet may have become hot. Onthespeakersystem This speaker system is not magnetically shielded, and the picture on nearby TV sets may become magnetically distorted. [. . . ]