User manual SONY VAIO VGN-CS385J/W

[. . . ] Caution The use of optical instruments with this product will increase eye hazard. Listening for many hours at maximum volume may damage your hearing. CAUTION -- INVISIBLE LASER RADIATION WHEN OPEN AVOID EXPOSURE TO BEAM Information IN NO EVENT SHALL SELLER BE LIABLE FOR ANY DIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE, OR LOSSES OR EXPENSES RESULTING FROM ANY DEFECTIVE PRODUCT OR THE USE OF ANY PRODUCT. For customers in the USA Owner's Record The serial number is located at the rear of the disc compartment lid and the model number is located at the top and bottom. [. . . ] Each time you press MENU. , the display changes as follows. Locking the controls (HOLD) To prevent the buttons from being accidentally operated when you carry the recorder, use this function. HOLD LapTim (erapsed time) r 1 Rem (remaining time of the current track) r AllRem (remaining time after current location) 1 Slide HOLD in the direction of the . . 3 Press ENTER. The display changes as follows. To unlock the controls Slide HOLD in the opposite direction of the arrow. A A Elapsed time B B Track number 23-GB Connecting to a stereo system Connect the i jack of the recorder to the LINE IN jacks of an amplifier or a recorder with a line cable (not supplied). The recorder plays the MD digitally and sends analog signals to the externally connected equipment. Portable DAT recorder, etc. Stereo system, etc. to LINE IN Stereo mini-plug 2 phono plugs L (white) RK-G136 (not supplied) R (red) RK-G129 (not supplied) to i 1 Press N to start playing. Notes · Even when connecting to the externally connected equipment, the Mega Bass function is operative. If you do not want the effect of the Mega Bass function on your recording or the output from the externally connected equipment, set "BASS" to "OFF" (page 22). · When recording to an externally connected equipment, press VOL +/­ repeatedly to adjust the volume level until "VOL 27" appears in the display, which is optimum for recording to an externally connected equipment. 24-GB Editing recorded tracks You can edit your recordings by adding/ erasing track marks or labeling tracks and MDs. Premastered MDs cannot be edited. Notes on editing · Do not move or jog the recorder while "Edit" is flashing in the display. · You cannot edit tracks on an MD that is record-protected. Before editing tracks, close the tab on the side of the MD (page 31). · If you perform an editing operation while playing, be sure not to turn the power off until "Edit" disappears in the display. · The lid does not open until "Edit" disappears in the display after editing. 2 Press >MENU. "00:00" appears in the display. "MK 003" appears in the display for 2 seconds. "MK OFF" appears in the display. The track mark is erased and the two tracks are combined. Moving recorded tracks You can change the order of the recorded tracks. Example Move track C from the third to the second track Before moving 3 A B C D z When you erase a track mark, name assigned to the mark is also erased. A C B D After moving x Notes · You cannot erase a track mark that has been written between track marks recorded in different recording mode, If you try to erase such a track mark, "SORRY" appears in the display. · You cannot erase a track mark that has been written between a track recorded through a digital connection and a track recorded through an analog connection. If you try to erase such a track mark, "SORRY" appears in the display. >MENU. ENTER 1 While playing the track you want to move, press ENTER, press >MENU. repeatedly until "EDIT" flashes in the display, and then press ENTER again. " " and "Name" flash in the display and the recorder plays the selected track repeatedly. repeatedly until " " and "Move" flash in the display, and then press ENTER. For the example above, "003 t" and "t 003" appear alternately in the display. For the example above, "003 t" and "t 002" appears in the display. [. . . ] · There is no more space for new data when you are editing the MD. · You tried to record or edit on a track that is protected from erasing. , Record or edit on other tracks. NoDISC No SIG PbONLY SAVED SORRY TEMP TrFULL TrPROT 36-GB Specifications System Audio playing system MiniDisc digital audio system General Power requirements Sony AC power adaptor connected at the DC IN 3V jack (supplied with the European, Chinese and Argentine models only): 120 V AC, 60 Hz (U. S. A. , Canadian and Taiwan model) 230 V AC, 50/60 Hz (Europe continental model) 240 V AC, 50 Hz (Australian model) 220 V AC, 50 Hz (Chinese model) 230 - 240 V AC, 50 Hz (U. K. and Hong Kong model) 220 V AC, 50 Hz (Argentina model) 110/220 V AC, 60 Hz (Korean model) 100 - 240 V AC, 50/60 Hz (Other models) One LR6 (size AA) alkaline dry battery (not supplied) Laser diode properties Material: GaAlAs Wavelength: = 790 nm Emission duration: continuous Laser output: less than 44. 6 µW (This output is the value measured at a distance of 200 mm from the lens surface on the optical pick-up block with 7 mm aperture. ) Recording and playback time When using MDW-80: Maximum 160 min. [. . . ]