User manual SONY VAIO VGN-CS390JKV

[. . . ] · When you replace the batteries, insert the new ones within 3 minutes after you remove the exhausted ones. Otherwise, the display may show the clock setting display or incorrect date and time when you re-insert the batteries. In this case, set the date and time again. The recorded messages and alarm setting, however, will remain. [. . . ] Please note that recorded messages may be erased during service or repair work. 1 Select the folder. Turn the jog lever toward FOLDER repeatedly to display the folder (A, B, C, D or E) in which you wish to record messages. Selected folder When the DPC switch is set to "ON" to start playback rapidly x Display during setting the menu In menu setting mode, the menu items and current setting are displayed. You can change the setting while it is flashing. LP recording mode is being selected. * If you have set a bookmark on the message, the unit stops at the bookmark. **These operations are for when EASY-S is set to "oFF". For operations when EASY-S is set to "on", see "Operating the Menu". x Error messages The error messages or error numbers will be displayed. When an access error occurs Operating the Menu You can use the menu to change the IC recorder settings. During playback and recording, the menu items to be displayed are limited. Follow the procedures below to display the menu and change the settings: 1 Turn the jog lever toward MENU. 2 Press the jog lever up or down (>/. ) to select the menu item for which you want to change setting. The setting mode of the selected menu item will be displayed. You can set the OPR indicator to turn off even in operation. BOther Information Specifications Recording media Built-in flash memory 128 MB (ICD-SX46) / 256 MB (ICD-SX56) / 512 MB (VAIO VGN-CS390JKV), Stereo/Monaural recording Recording time See "Recording Messages". Frequency range · ST: 60 Hz - 13, 500 Hz · STLP: 60 Hz - 6, 900 Hz · SP: 60 Hz - 7, 000 Hz · LP: 80 Hz - 3, 500 Hz Speaker Approx. Power output 150 mW Input/Output · Microphone jack (minijack, stereo) ­ input for plug in power, minimum input level: 0. 6 mV, 3 kilohms or lower impedance microphone · Headphones jack (minijack, stereo) ­ output for 8 - 300 ohms headphones · USB connector · DC IN 3V jack (For Korean and the People's Republic of China models, this jack does not exist. ) Playback speed control +100% to ­50% (DPC) Power requirements Two LR03 (size AAA) alkaline batteries: 3 V DC Dimensions (w/h/d) (not incl. projecting parts and controls) 28. 0 × 120. 0 × 13. 8 mm (1 1/8 × 4 3/4 × 9/16 in. ) Mass (incl. batteries) 64 g (2. 26 oz) Supplied accessories Stereo headphones × 1 USB connecting cable × 1 Application Software (CD-ROM) × 1 LR03 (size AAA) alkaline batteries x 2 Carrying pouch x 1 Optional accessories Stereo headphones MDR-EX71SL, MDRE931LP/Active speaker SRS-T88, SRS-T80/ Electret condenser microphone ECM-CS10, ECM-TL1, ECM-DS70* (* for Tourist model only)/Audio connecting cable RK-G134HG, RK-G135HG, RK-G136HG, RK-G139HG (excluding Europe)/AC power adaptor ACE30HG (excluding the models for Korea, the People's Republic of China, Australia, and New Zealand) Your dealer may not handle some of the above listed optional accessories. Please ask the dealer for detailed information. Design and specifications are subject to change without notice. Precautions On power · Operate the unit only on 3 V DC. Use two LR03 (size AAA) alkaline batteries. On safety · Do not operate the unit while driving, cycling or operating any motorized vehicle. On handling · Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Should any solid object or liquid fall into the unit, remove the batteries and have the unit checked by qualified personnel before operating it any further. [. . . ] Note Once a recording has been erased, you cannot retrieve it. REC-OP OFF · REC-OP in the menu is se to "oFF" and you cannot add or overwrite a recording. SET DATE · If you do not set date and time, you cannot make alarm setting. To set date and time, see "Step 2: Setting the Clock". 1 2 To resume normal playback Press the jog lever (x·B). To stop A-B Repeat playback Press xSTOP. Play back the message you want to move. Turn the jog lever toward FOLDER repeatedly to select the folder that you want to move the message into. The destination folder and "MOVE" flash. [. . . ]