User manual SONY VAIO VGN-NW380F/B

[. . . ] Bluetooth is a trademark owned by its proprietor and used by Hewlett-Packard Company under license. The information contained herein is subject to change without notice. The only warranties for SONY products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. [. . . ] Ensure that mechanized equipment used for moving materials is wired to ground and that proper materials are selected to avoid static charging. When grounding is not possible, use an ionizer to dissipate electric charges. Maintenance and Service Guide 4­5 Removal and Replacement Preliminaries 4. 6 Workstation Precautions Use the following grounding precautions at workstations: Cover the workstation with approved static-shielding material (refer to Table 4-2, "Static-Shielding Materials"). Use a wrist strap connected to a properly grounded work surface and use properly grounded tools and equipment. Use conductive field service tools, such as cutters, drivers, and vacuums. When fixtures must directly contact dissipative surfaces, use fixtures made only of static-safe materials. Keep the work area free of nonconductive materials, such as ordinary plastic assembly aids and Styrofoam. Handle electrostatic-sensitive components, parts, and assemblies by the case or PCM laminate. Handle these items only at static-free workstations. Avoid contact with pins, leads, or circuitry. Turn off power and input signals before inserting or removing connectors or test equipment. 4. 7 Grounding Equipment and Methods Grounding equipment must include either a wrist strap or a foot strap at a grounded workstation. When seated, wear a wrist strap connected to a grounded system. Remove the hard drive by following these steps: a. Loosen the 2 PM2. 0×4. 0 screws 1 that secure the hard drive cover to the notebook. Lift the left side of the hard drive cover and swing it to the right 2. drive cover is included in the Miscellaneous The hardKit, spare part number 378236-001. Plastics Removing the Hard Drive Cover Maintenance and Service Guide 5­7 Removal and Replacement Procedures Hard Drive Spare Part Number Information 5400-rpm 80-GB 60-GB 40-GB 380108-001 378215-001 380107-001 4200-rpm 80-GB 60-GB 30-GB 378214-001 378213-001 378211-001 d. Loosen the PM2. 5×13. 0 spring-loaded hard drive retention screw 1. Grasp the mylar tab 2 on the left side of the hard drive and slide the hard drive to the right 3 to disconnect it from the system board. Remove the hard drive from the hard drive bay 4. Removing the Hard Drive 5­8 Maintenance and Service Guide Removal and Replacement Procedures g. Remove the 2 PM2. 5×4. 0 hard drive frame shoulder screws 1 from each side of the hard drive. Remove the 2 PM2. 5×4. 0 hard drive frame screws 2 from each side of the hard drive. Remove the 2 PM1. 5×3. 5 hard drive frame screws 3 from the front of the hard drive. [. . . ] Power cord set fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country where it will be used. The flexible cord must be Type SPT-3 or equivalent, No. The wall plug must be a two-pole grounding type with a NEMA 5-15P (15 A, 125 V) or NEMA 6-15P (15 A, 250 V) configuration. The appliance coupler, flexible cord, and wall plug must bear a "T" mark and registration number in accordance with the Japanese Dentori Law. [. . . ]