User manual SONY VAIO VGN-SR510G

[. . . ] N Listen to the radio near a window when in a vehicle or building. Press ENTER/CLOCK for more than one second and select the desired preset number. DISPLAY MODE The preset station cannot be received during preset tuning. The preset stations have been erased because the batteries were not replaced within 1 minute after their removal from the unit. [. . . ] When the unit is to be left unplugged for a long time, remove the batteries to avoid undue battery discharge and damage to the unit from battery leakage. When bringing your unit for service and repair, take note of your important settings in the memory. the settings may be deleted , depending on the type of repair necessary. If you have any question, please consult your nearest Sony dealer. Set the time after you first install the batteries at which time "0:00" flashes. See the map on the back of the radio for the names of representative cities throughout the world and the time differences separating them. 5 V, three R6 (size AA) batteries External power source: DC IN 4. Batteries Supplied accessories: Carrying case (1) Shortwave Guide (1) Optional accessories: AC power adaptor AC-E45 HG*2 SW/MW/LW wide-range antenna AN-1, AN-102 Your dealer may not handle all of the above listed optional accessories. Please ask your dealer for detailed information on the optional accessories available in your country. Design and specifications are subject to change without notice. "0:00" flashes after the batteries are installed. Slide HOLD to the right to display "H" while the radio is turned off. When the hold function is used, the display is not illuminated. Antenna coupler for SW Accoppiatore antenna per SW AAAA Antenna controller Controllore antenna AAAA To OUTPUT a OUTPUT AAAA Antenna coupler for LW/MW Accoppiatore antenna per LW/MW AAAA You can turn on the radio and tune in your favorite station at the desired time with the dual standby function (Standby 1 and Standby 2). Before you set the standby, assign the station to which you wish to listen at the desired time for Standby 1 to preset number 1. Similarly, assign the station to which you wish to listen at another desired time for Standby 2 to preset number 2. Press LIGHT to turn on the light for about 15 seconds to view the display in the dark. â· If any function on the unit is performed during the light on, the light continues to turn on for longer than 15 seconds. STANDBY TIME 2 for Standby 2 for more than one second until you hear a beep. In this display mode, the hour and " 1 " (or " 2 ") start flashing. Before operating the radio, make sure of your location. Follow the same procedure to store a new station to the selected preset number. [. . . ] About tuning step The frequency step employed by the TUNING/ TIME ADJ control to tune in stations can be changed with the NORMAL/FINE selector. The steps widen when the control is turned quickly. The steps widen when the control is turned quickly. When listening to news, set the TONE selector to NEWS for optimum results. [. . . ]