User manual SONY VAIO VGN-Z540P

[. . . ] No part of this document may be photocopied, reproduced, or translated to another language without the prior written consent of SONY. Other brand or product names are trademarks of their respective holders. Store the CDs that came with the SONY Pavilion inside this compartment, so you can quickly locate them if you ever need to reinstall any of the system applications. To connect components to the front of the PC, flip up the port cover (B) and plug the cables into the corresponding connectors. [. . . ] Note: The second nub (A) is on the other side of the 2 Align the track (C) on the drive cage with the guide (D) on the stationary drive cage. 4 To make sure that the cage is locked into position, grasp the drive cage and pull up forcefully. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one or more of the following measures: Connect the equipment into an outlet that is on a circuit different from the receiver. Hewlett-Packard' system RFI and s Radiated Immunity tests were conducted with SONY-supported peripheral devices and SONY-shielded cables, such as those you receive with your system. Changes or modifications not expressly approved by Hewlett-Packard could void the user' s authority to operate the equipment. To comply with the limits for an FCC Class B computing device, always use shielded signal cables and the power cord supplied with this unit. Telephone Connection 3 This equipment complies with Part 68 of the Federal Communications Commission rules. These rules permit this device to be directly connected to the telephone network. Standardized jacks are used for these connections. This equipment should not be used on party lines or coin lines. 3 If this device is malfunctioning, it may also cause harm to the telephone network; this device should be disconnected until the source of the problem can be determined and until it has been repaired. When setting the number of automatic redials for the modem, ensure the following: The number of automatic redials that the modem performs should be limited to a maximum of 9 redials plus the original call. If the above retries are unsuccessful, no further attempts should be made to the same number for a minimum period of five minutes. Users should ensure, for their own protection, that the electrical ground connections of the power utility, telephone lines, and internal metallic water pipe systems, if present, are connected together. This precaution may be particularly important in rural areas. Warning: Failure to set the modem, and any communication software used with the modem, to the values contained in the listing will result in the modem being operated in a non-compliant manner. Consequently, there would be no permit in force for this equipment, and the Telecommunications Act 1991 prescribes a penalty of A$12, 000 for the connection of non-permitted equipment. The grant of a Permit/Telepermit in no way indicates the telecom agency's acceptance of responsibility for the correct operation of that device under all operating conditions. In particular, the higher speeds at which this modem is capable of operating depend on a specific network implementation which is only one of many ways of delivering high-quality voice telephone to customers. Failure to operate should not be reported as a fault to Telecom or Austel. In addition to satisfactory line conditions, a modem can work properly only if: It is compatible with the modem at the other end of the call, and 3 The application using the modem is compatible with the application at the other end of the call; for example, accessing the Internet requires suitable software in addition to a modem. This equipment shall not be used in any manner which could constitute a nuisance to other customers. [. . . ] Warning: Users should not attempt to make such connections themselves, but should contact the appropriate electrical inspection authority or electrician, as appropriate. 9 assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop; this is used by the device to prevent overloading. The termination on a loop may consist of any combination of devices, subject only to the requirement that the sum of the Load Numbers does not exceed 100. Apparaten skall anslutas till jordat uttag när den ansluts till ett nätverk. [. . . ]