User manual SONY VAIO VGN-Z570N/B

[. . . ] This document contains proprietary information that is protected by copyright. No part of this document may be photocopied, reproduced, or translated to another language without the prior written consent of SONY . Hewlett-Packard Company Home Products Division P Box 4010 . O. Cupertino, CA 95015-4010 USA ©Hewlett-Packard Company, 2000. [. . . ] 31-41 Joseph Street Blackburn, Victoria 3130, Australia European Hewlett-Packard GmbH. HQ-TRE Contact: Herrenberger Straße 110-140 D-71034 Böblingen, Germany (FAX: + 49-7031-14-3143) North America Hardware Quality Engineering Manager, Contact: Hewlett-Packard, SONYD, 10500 Ridgeview Ct. , Cupertino, CA 95015-4010, USA (Phone: 408-343-5000) FCC Regulatory and Safety Information (USA Only) Federal Communications Commission (FCC) Radio Frequency Interference Statement Warning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one or more of the following measures: n n Hewlett-Packard's system RFI and Radiated Immunity tests were conducted with SONY-supported peripheral devices and SONY-shielded cables, such as those you receive with your system. Changes or modifications not expressly approved by Hewlett-Packard could void the user's authority to operate the equipment. To comply with the limits for an FCC Class B computing device, always use shielded signal cables and the power cord supplied with this unit. Consumer Information and FCC Requirements Telephone Connection n Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet that is on a circuit different from the receiver. Consult the dealer or an experienced radio/TV technician for help. n n n This equipment complies with Part 68 of the Federal Communications Commission rules. Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request that the user disconnect the equipment. Users should ensure, for their own protection, that the electrical ground connections of the power utility, telephone lines, and internal metallic water pipe systems, if present, are connected together. This precaution may be particularly important in rural areas. Warning: Users should not attempt to make such connections themselves, but should contact the appropriate electrical inspection authority or electrician, as appropriate. Avertissement : L'utilisateur ne devrait pas tenter de faire ces connexions lui-même mais devrait utiliser les services de l'organisme approprié d'inspection des installations électriques ou d'un électricien, selon le cas. terminal device denotes the percentage of the total load to be connected to a telephone loop; this is used by the device to prevent overloading. The termination on a loop may consist of any combination of devices, subject only to the requirement that the sum of the Load Numbers does not exceed 100. Austel Statement (Australia Only) When setting the number of automatic redials for the modem, ensure the following: The number of automatic redials that the modem performs should be limited to a maximum of 9 redials plus the original call. If the above retries are unsuccessful, no further attempts should be made to the same number for a minimum period of five minutes. Warning: Failure to set the modem, and any communication software used with the modem, to the values contained in the listing will result in the modem being operated in a non-compliant manner. Consequently, there would be no permit in force for this equipment, and the Telecommunications Act 1991 prescribes a penalty of A$12, 000 for the connection of non-permitted equipment. Warning: The Load Number . 9 assigned to each Avertissement : La valeur de charge . 9 attribuée à chaque élément terminal indique le pourcentage de la charge totale pouvant être connecté à une boucle téléphonique. Cette valeur est utilisée pour éviter les surcharges. La terminaison d'une boucle peut être constituée d'une combinaison quelconque d'équipements, dans la mesure où la somme des valeurs de charge ne dépasse pas 100. Australia/New Zealand Telecom Statement Your modem has been granted an Austel Permit for use in Australia and a New Zealand Telecom Telepermit for use in New Zealand. In each country, special conditions apply to the settings and features of your modem. [. . . ] Vid felaktigt batteribyte föreligger risk för explosion. Ersätt bara med samma eller liknande batterityp, rekommenderad av tillverkaren. Gör dig av med batterierna enligt tillverkarens instruktioner. Advarsel: PCen bruker et litiumbatteri av typen CR2032. [. . . ]