User manual SONY VAIO VGN-Z590

[. . . ] Pin 1 is marked by a stripe on one side of the cable. Power connector Interface connector Pin 1 · A computer that supports UDMA mode 5 · A 40-pin 80-conductor cable (available from your dealer) · A software utility to confirm and activate Ultra ATA/100. Seagate · The Windows 98 operating system Handling Precautions ® provides a utility called UATA100. exe. You can download the latest version from our Web site at www. seagate. com. 2. Attach the interface connector and the power connector to the drive. [. . . ] The CHS addressing supports capacities up to 8. 4 Gbytes only. To access the full capacity of the drive, use LBA mode. BIOS Settings CHS Mode Drive Model Cylinders Heads Sectors ST340823A 16, 383 16 63 ST330621A 16, 383 16 63 ST320413A 16, 383 16 63 ST315311A 16, 383 16 63 ST310211A 16, 383 16 63 *One sector equals 512 bytes. Setting the Jumpers Refer to the jumper settings below to configure the drive for your system. Options jumper block Master or single drive Drive is slave Master with non ATAcompatible slave Cable select Limit drive capacity 40 Gbytes = 32 GB <40 Gbytes = 2. 1 Gbytes 7 5 31 LBA Mode Total Sectors* 78, 165, 360 58, 633, 344 39, 102, 336 29, 336, 832 19, 541, 088 8 6 4 2 Circuit Board Preparing the Drive with Disk Manager Installing a Single Drive If you are installing a single drive, we recommend using Disk Manager to automatically partition and format your drive. This software is stored on the CD provided with your drive. Boot your computer from your Windows 98 or 95 startup diskette. Insert the DiscWizard CD and change to the drive letter of your CDROM. Disk Manager guides you through the installation process. Proceed to the section on "Loading the Operating System. " 5. Why won't the drive format to full capacity?Verify that your BIOS has autodetect and LBA mode enabled. Otherwise you may need to use Disk Manager to achieve the full capacity of your drive. Back up the data on your drive before shipping it. Seagate assumes no responsibility for data lost during shipping or drive repair. Shipping a drive in an unapproved container voids the warranty. Do not use peanuts, bubble wrap or newspapers. Keep your original box and packing materials for storing or shipping your drive. To preserve the warranty status of your drive, any product returned to Seagate must be properly packaged in the original box or a Seagate-approved container to prevent physical and electrical damage while in transit. Electromagnetic Compliance for the European Union This model complies with the European Union requirements of the Electromagnetic Compatibility Directive 89/336/ EEC of 03 May 1989 as amended by Directive 92/31/EEC of 28 April 1992 and Directive 93/68/EEC of 22 July 1993. Compliance of this drive, as a system component, was confirmed with a test system. We cannot guarantee that your system will comply. The drive is not meant for external use (without properly designed enclosure, shielded I/O cable, etc. ). Das Gerrät ist ein Einbaugerät, das für eine maximale Umgebungstemperatur von 55°C vorgesehen ist. [. . . ] Boot your computer from your Windows 98 or 95 startup diskette with the Windows CD loaded. At the prompt, type x:\setup, where x is the drive letter of your CDROM drive. Continue with the Windows setup instructions. Troubleshooting If your drive is not working properly, follow these troubleshooting steps. A spinning drive produces a faint whine and clicking noise that begins when power is applied. [. . . ]