User manual SONY VAIO VGN-Z790DJB

[. . . ] Product may not be exactly as shown in the diagrams. Reproduction of this manual, or parts thereof, in any form, without the express written permission of SONY Technologies Inc. is strictly prohibited. Disclaimer While every precaution has been taken in the preparation of this document, SONY Technologies Inc. assumes no liability with respect to the operation or use of SONY hardware, software or other products and documentation described herein, for any act or omission of SONY concerning such products or this documentation, for any interruption of service, loss or interruption of business, loss of anticipatory profits, or for punitive, incidental or consequential damages in connection with the furnishing, performance, or use of the SONY hardware, software, or other products and documentation provided herein. [. . . ] Click this button to access Clone Mode overlay settings. These settings only apply to video content when viewed in dual-controller Clone mode. This allows you to reset the Overlay settings to default values. Saturation Hue Gamma Clone mode options Defaults button 17 Clone Mode Settings Clone Mode Options Standard Video content is displayed on your Primary display only. Video content is displayed on your Primary and Secondary displays. Video content is displayed on your Secondary display(s) is always in full screen mode. Note: your computer must be set for 16-bit color depth or higher to use this mode. Video content is displayed on your Primary and Secondary display is exactly the same manner. For example, all displays will show video output in full screen mode. These settings are available when Theater Mode is selected. The aspect ratio of the source video is maintained for full screen display. Note: that this option may result in black bars on either the horizontal or vertical sides of the video display. The source video is scaled so that your display is showing full screen. Note: if the source video contains horizontal black bars, as do some DVD movies, the full screen video will also contain black bars. Moving the slider to the right selects a higher quality base mipmap. Moving the slider to the left selects a lower quality mipmap. Wait for vertical sync will lower the frame rate of full screen games but reduce the image tearing that can occur with the higher frame rate. Selecting Application Preference allows the application to decide whether or not it should display its frames at the refresh rate of the monitor. Selecting Always Off allows the application to run at its highest possible frame rate, regardless of the monitor's refresh rate which is typically less than the frame rate at which the application will run. Truform uses High Order Surface geometry to generate more detailed and realistic terrain and character models for applications that support this technology. Select Application Preference to enable Truform. This button allows you to access advanced settings that can solve compatibility issues for a few specific Direct 3D® applications. This button allows you to reset the Direct 3D® settings to default values. Mipmap Detail Level slider Wait for Vertical Sync TRUFORM Compatibility Settings button Defaults 21 Direct 3D® Compatibility Settings Support DXT texture formats Enabling this allows applications to use this kind of texture format. There are a few applications that can only support a limited number of texture formats. By selecting Disabled, the driver will not support DXT texture formats, thus reducing the number of texture formats supported. [. . . ] Some single frequency monitors may not work with TV display enabled. If you experience problems when TV display is enabled, disable TV display to restore your monitor's display. Adjusting Monitor Display The size of the display on your monitor may be smaller and not perfectly centered when you have TV display enabled. These effects are caused by the changes required to provide a proper display on the TV. 34 Use the controls available on the Adjustments tab on the Monitor Properties page (accessible by clicking on the Monitor button on the SONY Displays tab) to adjust the display on your monitor only. [. . . ]