User manual SONY VAIO VGN-FW590FDH

[. . . ] Wireless Regulatory Information" on page 77. DANGER v To avoid electric shock hazard, connect and disconnect cables appropriately when installing, moving or opening the covers of this product or attached devices. Use the power cord with a properly grounded outlet. v Do not leave the base of your computer in contact with your lap or any part of your body for an extended period when the computer is functioning or when the battery is charging. Your computer dissipates some heat during normal operation. [. . . ] After a few moments, the main ConfigSafe window will return. If you need to restore a configuration snapshot, open ConfigSafe and follow the on-screen instructions. 30 ThinkPad® X Series Service and Troubleshooting Guide Solving computer problems Replacing the hard disk drive You can increase the storage capacity of your computer by replacing the hard disk drive with one of greater capacity. You can purchase a new hard disk drive from your SONY reseller or SONY marketing representative, or by visiting SONY on the Web. Note: Replace the hard disk drive only if you upgrade it or have it repaired. The connectors and bay of the hard disk drive were not designed for frequent changes, or drive swapping. Attention: Handling a hard disk drive: v Do not drop the drive or subject it to physical shocks. v Do not apply pressure to the cover of the drive. Incorrect handling can cause damage and permanent loss of data on the hard disk. Before removing the hard-disk drive, make a backup copy of all the information on the hard disk, and then turn the computer off. Never remove the drive while the system is operating, in standby mode, or in hibernation mode. To replace the hard disk drive, do the following: 1. Connect the ac adapter and the cables to the computer. Install a memory module To install the DIMM, do the following: 1. Turn off the computer, then disconnect the ac adapter and all cables from the computer. Close the computer display, and turn the computer upside down. Loosen the screw on the memory slot cover; then remove the cover. . 5. Attention: To avoid damaging the DIMM, do not touch its contact edge. With the notched end of the DIMM toward the right side of the socket, insert the DIMM, at an angle of about 20 degrees, into the socket 1 ; then press it firmly 2 . 7. Pivot the DIMM until it snaps into place. Make sure that the card is firmly fixed in the slot and not moved easily. 34 ThinkPad® X Series Service and Troubleshooting Guide Install a memory module 8. Replace the memory slot cover over the memory slot, aligning the back side of the cover first; then tighten the screw. Put the battery pack back in place and turn the computer right side up. To make sure that the DIMM is installed correctly, do as follows: 1. [. . . ] For registration and license please contact IBPT/BIPT. L'utilisation en extérieur est autorisée sur le canal 10 (2462 MHz) et 11 (2467 MHz). Dans le cas d'une utilisation privée, à l'extérieur d'un bâtiment, au-dessus d'un espace public, aucun enregistrement n'est nécessaire pour une distance de moins de 300m. Pour une distance supérieure à 300m un enregistrement auprès de l'IBPT est requise. [. . . ]