User manual SONY VGP-UHDP04

[. . . ] Record the serial number in the space provided below. Refer to this number whenever you call your Sony dealer regarding this product. ________________________________ The shielded interface cable recommended in this manual must be used with this equipment in order to comply with the limits for a digital device pursuant to subpart B of Part 15 of FCC. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. [. . . ] 12 hours Battery life may vary, depending on the files you back up. Continued on next page 9 Connecting the drive You can connect the drive to the computer using the supplied USB cable. Notes · Place the drive on a flat surface. · Do not connect the drive to an external USB hub. · Some computers may not operate the drive correctly due to lack of power. In this case, you need to use the AC adapter. For information on the AC adapter, call the Sony dealer where you purchased this product or a Sony service representative in your area. z Tip If you connect the drive with the computer for the first time, it takes time for a while to recognize the drive. After connecting the drive, double-click [My Computer], then check that the "[Local Disk (F:) ], etc. *" is added to [My Computer]. * "F:" is a name of drive and changed depending on the computer. 10 About the power management function (power save function) When using the computer's power management function (power save function), note the following points: · Set your computer so that it does not switch to a power save mode while the ACCESS indicator on the drive is flashing. For more information, refer to the manuals provided with your computer. · Before switching your computer to a power save mode, make sure the drive's ACCESS indicator is not illuminated, and then close applications that are running. · While the computer is in a power save mode, do not connect or disconnect the USB cable. Continued on next page 11 Disconnecting the drive from the computer Follow the procedure below to disconnect this drive from your computer. (The following procedures are for Windows XP. ) Notes · Before disconnecting the drive, close any open programs. · If the message below appears when you attempt to disconnect the drive, close any running software, wait for a while and then repeat the procedure. "Problem Ejecting USB Mass Storage Device. If the temperature changes drastically during operation, stop using the drive while keeping power to the drive turned on and let it stand for about an hour, then turn the power off. · Do not use the drive during periods of possible lightning strikes. Lightning can cause electric shock or damage the drive. To avoid fire, electric shock or damage to the product during periods of possible lightning strikes, disconnect the drive from the computer and unplug the drive from the power source. Furthermore, if you hear thunder, do not touch the drive or the computer. · Do not damage the cables. Cable damage can result in fire or electric shock. ­ When installing the product, do not place cables between the wall and a rack or shelf, where they could become pinched. ­ Do not damage or modify the cables in anyway. ­ Do not place any heavy objects on the cables, and avoid bending or pulling the cables unnecessarily. ­ Do not place the equipment near a heater or allow the equipment to become hot. ­ Always grasp the plug when removing cables. [. . . ] Also refer to the manuals provided with your computer. Symptom The hard disc drive is not recognized by the computer (The icon of the hard disc drive does not appear in [My Computer]. ), or does not work properly. Cause/Remedy c If the computer returns from hibernation to normal operating mode or turns on while the drive is connecting, the computer may not recognize the drive correctly. In this case, disconnect the USB cable from the device and reconnect it. c The drive may not be connected correctly to the computer with an USB cable. See "Connecting the Drive" on page 10. [. . . ]