User manual SONY VGP-UMS20

[. . . ] All other names of systems, products, and services are trademarks of their respective owners. In this manual, the TM or ® marks are not specified. When you clean the mouse, make sure to remove the batteries. Clean the outside of the mouse with a soft, dry cloth or a soft cloth lightly moistened with a mild detergent solution. [. . . ] Caution - Repair and maintenance of this equipment should be made only by Sony authorized technicians. Improper repairs and use can create safety hazards. Caution - Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. You can find the following sticker on the bottom of the equipment. Case C 1 Open the button cover to turn the mouse on. Avoid using on such surfaces, or use a commercially available mouse pad that is compatible with a laser sensor mouse. C If the CONNECT button is pressed while operating the mouse, the mouse goes into a standby mode for about 3 minutes and cannot be operated during this time. If you press the CONNECT button, close the button cover and open it before starting to work with the mouse. If you open the button cover, this mode is Lights up green (steady), then turns off entered after a few seconds. If you push the CONNECT button, the flashing status light indicates that the mouse is waiting to connect to the personal computer. About connecting, see "Enabling communication between the mouse and your personal computer. Insert the two supplied LR03 (size AAA) batteries using the correct +/­ orientation. For installing the batteries, please refer to the "Inserting Batteries into the Mouse" section of this manual. Batteries may explode or leak if recharged, disposed of in fire, mixed with other types of battery or improperly installed. Batteries used in these devices may present a fire or chemical burn hazard if mistreated. Do not disassemble, heat above 60 °C or incinerate. In some areas, the disposal of batteries in household or business waste may be prohibited. Communication status between the mouse and your personal computer may not have been properly established. Make sure your personal computer is set as below. For details on how to set the WIRELESS switch or Bluetooth function, refer to the manuals provided or included with your personal computer. Close the button cover once, after a few seconds, open it to connect to the personal computer. For details on connecting, see "Enabling communication between the mouse and your personal computer. [. . . ] C Avoid using on such materials, or use a commercially-available mouse pad that is compatible with a laser sensor mouse. Open the button cover to turn the mouse on. When you move the mouse, the pointer displayed on your screen moves in the same direction. Due to the characteristics of the laser sensor, the mouse may not work properly on transparent surfaces or on a mouse pad that has a clear surface. [. . . ]