User manual SONY VGP-UVC100

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference using one or more of the following measures: ­ Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. [. . . ] : 858-942-2230 (This phone number is for FCC-related matters only. ) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The specifications are the same as those of the notebook you are using. for details , refer to the manuals provided with your notebook. This connector cannot be used if your notebook processes graphics with an Intel® Graphics Media Accelerator. Be sure to use the AC adaptor (PCGA-AC19V9) supplied with the unit. The AC adaptor supplied with your notebook is not compatible. May not be supplied in some countries or regions. Design and specifications are subject to change without notice. Use the AC adaptor (PCGA-AC19V9) supplied with the unit. See also the manuals provided with your notebook for more information about connecting the docking station. the Sony VGP-UVC100 docking station is designed for Sony notebooks. However, it may not be used with some models. Before attaching the docking station to your notebook, you need to adjust the position of the size adjuster on the docking station to match the size of your notebook. This operation is not necessary when connecting to the VGN-FE500 Series. Clean the unit with a soft dry cloth or a soft cloth lightly moistened with a mild detergent solution. Do not use any type of solvent, such as alcohol or benzine, which may damage the finish. Using a coin or similar object, remove the fastening screw from the bottom of the docking station. ) Adjust the position of the size adjuster to match the size of your notebook. ) Reinsert the fastening screw into the bottom of the docking station. For details about operations or installation on the notebook connected to the docking station, refer to the manuals provided with your notebook. [. . . ] Press in the bay unit eject button until you hear it click, and then install the separately purchased bay unit in the multi function bay of the docking station. Slowly insert the bay, label side up, until you hear it click into place. If the bay unit has a security screw Install the security screw and fasten the bay unit to the docking station using the Lshaped screwdriver supplied with the bay unit to prevent theft. When removing the bay unit while the power of the docking station is on, make sure to perform the following procedure. [. . . ]