User manual SONY VGPPRS20

[. . . ] The bracket and the protection collar are attached to the unit before shipping. Before mounting the unit, use the release keys to remove the bracket and the protection collar from the unit. Keep the release keys for future use as they are also necessary if you remove the unit from your car. Caution Handle the bracket carefully to avoid injuring your fingers. [. . . ] Note Before installing, make sure that the catches on both sides of the bracket are bent inwards 2 mm. If the catches are straight or bent outwards, the unit will not be installed securely and may spring out. Note (-A) Be sure to connect the earth lead before connecting the amplifier. Tip (-B- ) For connecting two or more CD/MD changers, the source selector XA-C30 (optional) is necessary. Connecting any other system may damage the unit. To the interface cable of a car telephone To the parking brake switch cord To auxiliary equipment such as portable audio player To a digital amplifier or audio device If you have a power aerial without a relay box, connecting this unit with the supplied power connecting lead may damage the aerial. notes on the control power and suppy leads · The power aerial control lead (blue) supplies +12 V DC when you turn on the tuner, or when you activate the AF (Alternative Frequency) or TA (Traffic Announcement) function. When your car has built-in FM/MW/LW aerial in the rear/side glass, connect the power aerial control lead (blue) or the accessory power input lead (red) to the power terminal of the existing aerial booster. A power aerial without a relay box cannot be used with this unit. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. Consult your car dealer or your nearest Sony dealer for further details. Note If the parking brake switch cord is too thin, connect the parking cord (Light green) of to the parking brake switch cord directly without using the tap . When connecting to a digital amplifier or audio device equipped with a Dolby digital decoder, connect the optical cable to the DIGITAL OUT on the back panel. notes · Do not bend the optical cable too much. If it is bent in an arc of less than 10 cm in diameter, sound may not be reproduced. Be sure to use an optical cable (not supplied) designed for Sony car audio systems. Make sure the optical cable does not get compressed or constricted in any way by surrounding objects. Never let the coupler parts of the connectors get scratched or become contaminated with dirt. Before installing the unit, remove the protection collar and the bracket from the unit. Engage the release keys together with the protection collar . [. . . ] Engage the release keys together with the protection collar . Pull out the release keys to remove the protection collar . Insert both release keys together between the unit and the bracket until they click. Pull down the bracket , then pull up the unit to separate. [. . . ]