User manual SONY VAIO VPCB11PGX

[. . . ] The following are registered trademarks of IBM Corporation: IBM, IBM PC AT, IBM PS/2. The following are registered trademarks of Microsoft Corporation: MS, MS-DOS, Windows. PCMCIA is a trademark of the Personal Computer Memory Card International Association. EarthLink is a registered trademark of EarthLink Network, Inc. [. . . ] Adjust the sound volume control settings in your software, operating system and applications. Plugging in headphones disables the built-in speakers, remove the headphones. Refer to your application and operating system documentation for help. The software volume control is set too low. Headphones are plugged into your notebook. Software driver is not configured correctly. Floppy Disk Drive Problems You cannot access your floppy disk. You tried to write to a write protected floppy disk. The floppy disk drive may not be properly installed. Security is set to protect access to floppy disk data. Hard Drive Problems You cannot access your hard drive. The setup utility is incorrectly set for your internal (Primary Master) or optional second hard drive (Primary Slave). You have a memory failure. Remove and re-install your memory upgrade module. (See Memory Upgrade Module on page 39 for more information) Check for Power On Self Test (POST) messages. (See Power On Self Test Messages on page 47 for more information) Messages about modem operation are generated by whichever modem program is in use. See your application software documentation for additional information. The device is not properly installed. The device may have been installed while an application was running, so your notebook is not aware of its installation. Your software may not have the correct software driver active. You may have the wrong I/O address selected for your device. Remove and re-install the device. (See Device Ports on page 35 for more information) Close the application and restart your notebook. See your software documentation and activate the correct driver. See your device documentation and software documentation to determine the required I/O address. Change the settings in the BIOS setup utility. (See BIOS Setup Utility on page 23 for more information) 41 B5FH-4881-01EN-00. book Page 42 Thursday, January 17, 2002 10:43 AM LifeBook P Series ­ Section Five Problem Possible Cause Possible Solutions You have installed a USB device, but your LifeBook notebook does not recognize the device, or the device does not seem to work properly. (continued) PC Card Problems A card inserted in the PC Card slot does not work or is locking up the system. Your device and another device are assigned the same I/O address. Check all I/O addresses located within the BIOS setup utility and any other installed hardware or software to make sure there are no duplications. The card is not properly installed. [. . . ] The termination on a loop may consist of any combination of devices such that the total of the load numbers of all devices does not exceed 100. CAUTION For safety, users should ensure that the electrical ground of the power utility, the telephone lines and the metallic water pipes are connected together. Users should NOT attempt to make such connections themselves but should contact the appropriate electric inspection authority or electrician. This may be particularly important in rural areas. 68 Avis Aux Utilisateurs Du Réseau Téléphonique Canadien L'étiquette canadienne Industrie Canada identifie l'équipement certifié. [. . . ]