User manual SONY VAIO VPC-EA27FX/G

[. . . ] . 2 Notice © 2001 Compaq Computer Corporation. Compaq, the Compaq logo, and Evo are trademarks of Compaq Information Technologies Group, L. P. Microsoft, MS-DOS, Windows, Windows NT are trademarks of Microsoft Corporation. [. . . ] Intel, Pentium, Intel Inside, and Celeron are trademarks of Intel Corporation. All other product names mentioned herein may be trademarks of their respective companies. Compaq shall not be liable for technical or editorial errors or omissions contained herein. The information in this document is provided "as is" without warranty of any kind and is subject to change without notice. The warranties for Compaq products are set forth in the express limited warranty statements accompanying such products. Nothing herein should be construed as constituting an additional warranty. The information in this publication is subject to change without notice. This publication does not constitute an endorsement of the product or products that were tested. The configuration or configurations tested or described may or may not be the only available solution. For additional information about this patch, you may refer to Microsoft Knowledge Base Article Q192841, found here: http://support. microsoft. com/support/kb/articles/Q192/8/41. ASP?LN=ENUS&SD=gn&FR=0&qry=Q192841&rnk=1&src=DHCS_MSPSS_gn_SRCH&SPR=W95 On some platforms, including Evo Desktops, the patch cannot be run by following the procedures outlined in the Microsoft Knowledge Base article, because the affected platform cannot start Windows 95 in Safe Mode. The following alternate procedure can be used in these cases: 1. Connect to the Internet and browse to the Microsoft Web site at http://www. microsoft. com/windows95/downloads/contents/WURecommended/S_WUServicePa cks/AMDPatch/Default. asp to download AMDK6upd. exe. 2. 3. Save AMDK6upd. exe to a bootable floppy disk. Extract the files from AMDK6upd. exe to the floppy by executing: AMDK6upd. exe /T:a:\ /C Switches are documented; run AMDK6upd. exe /?5. Start the Windows 95 installation, following normal procedures. The first time you start the computer after installing Windows 95, an error may occur, or the computer simply many not start. Insert the diskette created in step 2, above, and restart the computer. [. . . ] Insert the diskette created in step 2, above, and restart the computer. Manually copy the updated driver files on the diskette to the hard drive folders shown below. * You can create a batch file to perform this task if you need to do this on many computers. Locations for each of the files are: scsiport. pdr - copy to C:\Windows\System\IOSubsys disktsd. vxd - copy to C:\Windows\System\IOSubsys esdi_506. pdr - copy to C:\Windows\System\IOSubsys hsflop. pdr - copy to C:\Windows\System\IOSubsys cdfs. vxd - copy to C:\Windows\System\IOSubsys vfbackup. vxd - copy to C:\Windows\System\VMM32 ios. vxd - copy to C:\Windows\System\VMM32 int13. vxd - copy to C:\Windows\System\VMM32 6. * These paths assume that Windows 95 is being installed to C:\Windows. [. . . ]