User manual SONY VAIO VPC-EB190X

[. . . ] patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited. SONY shall not be liable for technical or editorial errors or omissions contained herein. [. . . ] If the notebook cannot read a CD or DVD · For a single-sided CD or DVD, make sure the disc is placed in the drive with the label facing up. · Wait 5 to 10 seconds after closing the tray to give the notebook time to recognize the disc. Reference Guide 67 Troubleshooting and Maintenance Troubleshooting Your Notebook · Restart the system: remove the disc from the drive, and select Start > Turn Off Computer > Restart. · If you created the CD on a DVD/CD-RW combo-type drive, try using a different media brand. Read and write quality may vary for media. If a DVD movie doesn't fill the screen Each side of a double-sided DVD has a different format (standard or widescreen). In widescreen format, black bands appear at the top and bottom of the screen. To view the standard format, flip the disc over and play the other side. If a DVD doesn't play with two displays If you're using the Extended Desktop (dual displays), move the player window to the display selected as primary. If you're not using Extended Desktop and both displays are active, press Fn+F5 to switch to one display. If the notebook can't find Wordpad. exe after inserting a CD The system is trying to open a . doc file in WordPad, but cannot find the Wordpad. exe program file. Type C:\Program Files\Accessories in the error message box. Display problems If the notebook is on, but the screen is blank · Move the mouse or tap the TouchPad. (The notebook infrared port is located on the front of the notebook. ) The ports should be no more than 1 meter apart. · Check settings in the Device Manager: 1. Select Start > Control Panel > Performance and Maintenance > System. On the Hardware tab, select Device Manager and expand the infrared devices. Double-click the infrared port and make sure that the device is enabled. · Make sure only one application is using the infrared port. 70 Reference Guide Troubleshooting and Maintenance Troubleshooting Your Notebook Keyboard and pointing device problems Use these suggestions for built-in or external devices. If the pointer is difficult to control Adjust the pointer controls. Select Start > Control Panel > Printers and Other Hardware > Mouse. If the TouchPad doesn't work · Press the TouchPad on-off button to turn on the light. · Don't touch the TouchPad while the notebook is rebooting or resuming from Standby mode. If this happens, try the following: press a key on the keyboard to restore normal operation. [. . . ] Telecom will accept no responsibility should difficulties arise in such circumstances. PTC200 5. 6. 1 (3) General Requirements (automatic dialing devices) This equipment shall not be set up to make automatic calls to Telecom's 111 Emergency Service. Reference Guide 107 Reference Information Regulatory Information PTC200 7. 5. 2 (3) (4) Ringer Sensitivity This device may be subject to ringing or bell tinkle when certain other devices are connected to the same line. If this occurs, the problem should not be referred to the Telecom Faults Service. Associated Software Limits of Compliance Some parameters required for compliance with Telecom's Telepermit requirements are dependent on the application software or PC equipment associated with this device. [. . . ]