User manual SONY VAIO VPC-EB1HFX/BI

[. . . ] © Copyright Hewlett-Packard Company 1998. Reproduction, adaptation, or translation of this manual is prohibited without prior written permission of Hewlett-Packard Company, except as allowed under the copyright laws. The programs that control this product are copyrighted and all rights are reserved. Reproduction, adaptation, or translation of those programs without prior written permission of Hewlett-Packard Co. [. . . ] Press the ejector button once to pop it out, then press it again to eject the PC card. Then pull out the card. 1-35 Using the Dock Making Connections To connect your audio equipment Note If you connect external speakers, the internal OmniBook speakers are automatically turned off. If you connect an external microphone, The internal microphone is automatically turned off. If you connect external speakers or microphone to the OmniBook, any speakers or microphone attached to the dock are automatically turned off. Line-in connector for an external audio source (such as a CD player). Amplified speakerout connector for headphones or speakers Microphone-in for an external microphone 1-36 2 Installing Accessories 1-37 Installing Accessories This chapter provides instructions on how to Install and use the module bay adapter. Install PCI accessory boards in the 2 PCI half-length slots. Install SCSI and IDE devices in the 5. 25-inch PC expansion device bay. Format hard disk drives installed in the PC expansion bay. Hewlett-Packard offers a wide selection of accessories for OmniBooks and the docking system. For information on accessories, see the SONY OmniBook website at www. hp. com/omnibook. 1-38 Installing Accessories Using the Module Bay Adapter Using the Module Bay Adapter The optional module bay adapter lets you use OmniBook plug-in IDE modules such as CD-ROM drives, LS-120 drives, or DVD drives with your dock. This section describes how to: · Install the module adapter in the plug-in module bay. · Install and remove plug-in modules. If you are inserting a CD-ROM drive, LS-120 drive, or DVD drive, shut down the OmniBook before removing or installing the module. This is required even if you have optional Tioman "hot-swap" software installed on your OmniBook. From the Start menu, shut down the OmniBook, ­or­ undock the OmniBook. 1-44 Installing Accessories Using the Module Bay Adapter 2. If the plug-in module is secured, remove the PCI board door and slide the module security latch to the unlocked position, then reinstall the PCI board door. 3. Press the eject button and remove the plug-in module from the dock. To install a plug-in module 1. From the Start menu, shut down the OmniBook, ­or­ undock the OmniBook. 1-45 Installing Accessories Using the Module Bay Adapter 2. Slide the plug-in module into the module bay until it clicks into place. 3. To secure the plug-in module (optional), remove the PCI board door and slide the module security latch to the locked position, then reinstall the PCI board door. For more information on using plug-in modules, refer to the OmniBook Reference Guide or the accessory documentation that accompanied the modules. Note To prevent unauthorized removal of the plug-in module, you must secure the dock. Your dock has a built-in security port that allows you to secure the dock with a cable. A Kensington MicroSaver lock system or compatible lock system works with this port and is available at many computer stores. [. . . ] Please have your dock and OmniBook with you. 1-70 Specifications and Regulatory Information Specifications Specifications Ports 240-pin docking connector. Parallel DB25 (EPP/ECP and floppy drive). VGA port, D-sub 15-pin female connector ­ DDC compliant. Three audio jacks for Speaker-out, Line-in, and Microphone-in. [. . . ]