User manual SONY VAIO VPC-EB24FX/T

[. . . ] Armada is a trademark of Compaq Computer Corporation. Contura is registered in the Philippines Patent Office. Microsoft, MS-DOS, and Windows are registered trademarks of Microsoft Corporation. Windows 95 is a trademark of Microsoft Corporation. [. . . ] Push the memory board firmly into place to seat the connections and to engage the locking tabs. Figure 7-14. Installing the Memory Board 7-18 Computer Removal and Replacement Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7. 9 Hard Drive NOTE: The 3-inch hard drive or the 2. 5-inch hard drive with carrier are interchangeable. The hard drive is held in place with two screws and a retaining bracket. To remove the hard drive and bracket, complete the following steps: 1. Disconnect the AC power and any external devices (Section 7. 4. 1). Remove the battery pack (Section 7. 4. 3). Remove the DualBay device (Section 7. 4. 4). Remove two screws and the hard drive retaining bracket that secure the hard drive in place. Figure 7-15. Removing the Hard Drive Bracket Computer Removal and Replacement Procedures 7-19 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7. Lift the hard drive from the hard drive compartment. Figure 7-16. Removing the Clutch Covers Reverse the procedure to install the clutch covers. 7-26 Computer Removal and Replacement Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7. 12. 2 Display Assembly To remove the display assembly, complete the following procedures: 1. Disconnect the AC power and any external devices (Section 7. 4. 1). Remove the battery pack (Section 7. 4. 3). Remove the DualBay device (Section 7. 4. 4). Remove the microphone/display cable cover (Section 7. 11). Remove the clutch covers (Section 7. 12. 1). Remove two screws from each clutch and the clutch tension plate that secure the display to the base enclosure 8. Disconnect the display cables from the base enclosure 9. Lift the display assembly from the base enclosure 1. 2. Figure 7-23. Removing the Display Assembly Reverse the procedure to replace the display assembly. CAUTION: To avoid damaging the display and ground cables, attach the ground cable before attaching the display cables when replacing the display assembly. Computer Removal and Replacement Procedures 7-27 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7. 12. 3 Clutches The two clutches act as hinges for the display assembly. To remove the clutches, complete the following procedures: 1. [. . . ] This command causes the modem to listen and wait for a 10 * n ms period of silence on the line. At the end of this period, the modem then responds OK. You can specify any number from 0 through 255 as the value of n; for example, a value of 5 specifies a period of 50 ms. This is a FAX command only, responds with the ERROR result code if in data mode. [. . . ]