User manual SONY VPCEG1BFX

[. . . ] Note to Consumer - Keep these instructions for future reference. skill level - Installation of this appliance requires basic mechanical and electrical skills. Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered under the Warranty. [. . . ] C L 30 to Cooktop Draw a vertical line on the wall at the center of the 30 space. Tape the Rear Wall Template onto the wall matching the centerline and touching the bottom cabinet frame. Plate position – beneath recessed bottom cabinet with front overhang Draw a line on the back wall equal to the depth of the front overhang. Your cabinets may have decorative trim that interferes with the microwave installation. Remove the decorative trim to install the microwave properly and to make it level. Use a level to make sure the cabinet bottom is level. If the cabinets have a front overhang only, with no back or side frame, install the mounting plate down the same distance as the front overhang depth. Measure the inside depth of the front overhang. Draw a horizontal line on the back wall an equal C L 30" to Cooktop distance below the cabinet bottom as the inside depth of the front overhang. For this type of installation with front overhang only, align the mounting tabs with this horizontal line, not touching the cabinet bottom as described in Step D. ALIGNING THE WALL PLATE Hole A Centerline notches Draw a Vertical Line on Wall from Center of Top Cabinet C L Horizontal Line Area E Hole B Horizontal Line Draw a Horizontal line on wall from bottom of “Rear Wall Template”. €¢ Drill the holes, following the instructions on the TOP CABINET TEMPLATE. CAUTION: Wear safety goggles when drilling holes in the cabinet bottom. IMPORTANT: Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. IMPORTANT: If filler blocks are not used, case damage may occur from over tightening screws. NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Make sure tape securing damper is removed and damper pivots easoly before mounting microwave. CAUTION: You will need to make adjustments to assure proper alignment with your house exhaust duct after the microwave is installed. Lift microwave, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate. Rotate front of oven up against cabinet bottom 3. [. . . ] CAUTION: Be careful to avoid pinching fingers between the back of the mounting plate and the wall. Pull the plate away from the wall to help tighten the bolts. The wires will BEFORE: Fan Blade Openings Facing Forward End B CAUTION: Do not pull or stretch the blower unit wiring. NOTE: The blower unit exhaust openings should match exhaust openings on rear of microwave oven. [. . . ]