User manual SONY VPCEG23FX/L

[. . . ] B -  eep these instructions for future reference. k - nstallation of this appliance requires basic mechanical and electrical skills. I • Note to Installer • Note to Consumer • Skill level • Proper installation is the responsibility of the installer. € Product failure due to improper installation is not covered under the Warranty. [. . . ] Backsplash NOTES: • The space between the cabinets must be 30˝ wide and free of obstructions. • This microwave oven is for installation over ranges up to 36˝ wide. € If you are going to vent your microwave oven to the outside, see the Hood Exhaust Section for exhaust duct preparation. € If installing the microwave oven beneath smooth flat cabinets, be careful to follow the instructions on the top cabinet template for power cord clearance. € Maximum cabinet depth above and beside the unit is 12˝. € The dimensions provided are the minimum required for mounting the microwave oven. Local codes and the practical use of the range will likely require you to provide more than the 13. 5˝ shown between the range and the bottom of the microwave. Removing the microwave oven from the carton/Removing the mounting plate 1. Remove the installation instructions, Exhaust adaptor, filters, glass tray, and the small hardware bag. Do not remove the Styrofoam protecting the front of the oven. Draw a second, horizontal line on the wall below the cabinet to mark how far the inside of the front overhang descends below the cabinet. Tape the Rear Wall Template onto the wall so that the top of the template touches the bottom of the horizontal line and the centerline on the template lines up with the vertical line. Draw a horizontal line to mark how far the inside of the front overhang descends below the cabinet. Th th A Hole A A Hole Centerline Centerline notches notches Draw a Horizontal line onVertical Linealong Draw a the wall on Wall from of “Rear the bottomCenter of Top Cabinet Wall Template”. C L Horizontal Horizontal Line Area E Area E Hole B Horizontal Line Horizontal Line Hole B Draw a Horizontal line on wall from bottom Horizontal line on wall from of “Rear “Rear Wall bottom ofWall Template”. Draw a Horizontal line on the wall at the bottom of the “Rear Wall Template”. Drill ⅝˝ holes for toggle bolts in 3 locations (Hole A, Hole B, Hole C) as shown in the illustration above. If the location of a hole lines up with a stud, drill a 3/16˝ hole for a wood screw. You cannot use a toggle bolt to attach the wall plate to a stud. If none of these holes line up with a stud, find a stud in area E that lines up with a hole circle in Area E, and then drill a 3/16˝ hole into it for a wood screw. You must have at least one wood screw mounted firmly into a stud to support the weight of the microwave. [. . . ] NOTE: If your cabinet is metal, use the nylon grommet in the power cord hole to prevent the cord from being cut. NOTE: Filler blocks are required when mounting this unit under any cabinet with a recessed bottom or front overhang. ) IMPORTANT: The case damage that will occur from over tightening screws if you do not use filler blocks is not covered under warranty. NOTE: When mounting the microwave oven, thread the power cord through hole in the bottom of top cabinet. [. . . ]