User manual SONY VAIO VPC-F1190X

[. . . ] Refer to the model and serial number when you call VAIO Link. Model Number: PCG-F160 / PCG-F190 Serial Number:________________________ WARNING u u u Opening the unit, for whatever reason, could lead to damages that are not covered by the guarantee. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. [. . . ] The hard disk and the video display enter a low power state and the CPU clock and processor stop. The power indicator light is red in this mode. To activate System Idle mode Press Fn+S. You can also enter system Idle mode by using the PowerPanel utility. To return to normal mode Press any key. You cannot resume from System Idle by clicking with a mouse or the touchpad. System Suspend Mode The computer saves the current state of the system in RAM and switches off power to the CPU. The red power red light flashes in this mode. 37 Sony Notebook Computer User Guide To activate System Suspend mode Press Fn+Esc, or slide the power switch forward quickly. You can also use the PowerPanel utility to enter System Suspend mode. If you slide the power switch forward and hold for more than four seconds, the computer switches off automatically. To return to normal mode Press any key. System Hibernation Mode The state of the system is saved on the hard drive and power is turned off. The power indicator light is off in this mode. To activate System Hibernation mode Press Fn+F12. You can also use the PowerPanel utility to enter System Hibernation mode. To return to normal mode Turn on the computer by sliding the power switch forward. The computer returns to its previous state. When returning from System hibernation mode, the system status stored on the hard disk is erased and the computer starts normally if you slide the power switch forward and hold for more than four seconds. u Time to return to normal mode: System hibernation § System suspend § System Idle System suspend requires less time than System hibernation. u Power consumption: System idle§ System suspend § System hibernation System idle uses more power than System hibernation. 38 Using Your Notebook Computer Using a Second Battery Pack You can purchase a second rechargeable battery pack. With two battery packs, you can extend the time that you use your computer with battery power. When using two battery packs, the battery pack you insert first charges first. Plug the other end into the GSM phone. Models of GSM Sony CMD-Z1 and Z1 Plus Sony CM-DX1000 and CMD-X2000 Other GSM phones Card programming Ready Ready to be re-programmed (program supplied on your Hard Disk and Recovery CD-ROM). See your retailer. Connecting to an ISDN line Your PC card modem is ready for connection to ISDN (Digital Network offering transmission of voice, data, fax). See your retailer for information and accessories. Connecting to a LAN (Ethernet) Your PC Card modem is ready for LAN connection (LAN adapter not supplied). See your retailer for information and accessories. Phone cable and connectors are TNV (Telecommunication Network Voltage), according to EN60950. 45 Sony Notebook Computer User Guide Port Replicator Your notebook computer supports the use of an optional port replicator. Attaching a port replicator enables you to connect additional peripherals to your computer. 1 2 3 4 / Network (ethernet) Monitor (page 50) Serial (page 53) Mouse/Keyboard (page 58) 5 6 7 USB (page 61) Printer (page 49) DC In (page 11) The port replicator can be powered only with an AC power adapter. Do not remove the AC adapter from the port replicator or the AC outlet while using the port replicator; this may cause data damage or hardware malfunctions. When you use the port replicator for the first time, the New Hardware installation window appears and the USB network drive is automatacally installed. When the installation is done, the message of System Setup change appears. All connectors are SELV (Safety Extra Low Voltage) according to EN60950. 46 Connecting Peripheral Devices To attach your computer to the port replicator To supply power to your computer while it is connected to the port replicator, you must connect the AC adapter directly to the port replicator. 1 2 Turn off your computer and disconnect all peripherals. On the bottom of the computer, lift the port replicator port cover. port replicator port 3 Attach the bottom of the computer to the port replicator connector until it clicks. Notebook computer Port replicator 4 Plug the cable attached to the AC adapter into the DC IN connector on the port replicator. Plug the power cord into the AC adapter and an AC outlet. AC adapter Power cord (hazardous voltage according to EN60950) SELV according to EN60950 47 Sony Notebook Computer User Guide 5 The power indicator light turns green Levers Power Port replicator connector 6 Turn on the computer. Use the AC adapter that comes with your computer or the optional Sony PCGA-AC71 adapter. [. . . ] If the telephone company makes a service call to your home or office and determines that your computer is responsible for a problem, the telephone company may bill you for the service call. Also, if you do not disconnect your computer when it is adversely affecting the telephone line, the telephone company has the right to disconnect your service until you correct the problem. u u u u u On Moisture Condensation If the computer is brought directly from a cold location to a warm one, moisture may condense inside your computer. In this case, allow at least an hour before turning on your computer. If any problems occur, unplug your computer, and contact your Sony Service Center. On Handling Diskettes u Do not open the shutter manually and touch the surface of the diskette. 77 Sony Notebook Computer User Guide u u Keep diskettes away from magnets. [. . . ]