User manual SONY VAIO VPCJ113FX/B DATASHEET

[. . . ] This file can be created on a single-partitioned or multiple-partitioned hard disk drive, and is subject to the following restrictions: It must be created on the primary hard disk drive. All partitions must be formatted before you create the hibernation file. The partitions must be formatted in either FAT16 or FAT32; you cannot use NTFS, the default file system for Windows NT. 3 Using the card stopper for the Mini-PCI Card The Mini-PCI Card is held in place by a card stopper shown in the drawing below. Following is the overall procedure for replacing the Mini-PCI Card. [. . . ] By default, the TrackPoint is set to Auto-Disable. When this setting is in effect, the TrackPoint is disabled automatically when a mouse is connected to the external-input-device connector. To enable the TrackPoint so that it will work simultaneously with a mouse, do the following: 1 2 3 4 5 Click Start Settings Control Panel. Double-click the ThinkPad Configuration icon. The ThinkPad Configuration window appears. Click the TrackPoint button on the left side of the window. Click OK. 7 Using the DVI monitor If you have a model A20p computer, you can use either of the following Digital Visual Interface (DVI) monitors through the DVI connector of an expansion unit--either a ThinkPad Dock or a ThinkPad Port Replicator: SONY T85D 18-inch TFT LCD Digital Color Monitor (DVI model) SONY T55D 15-inch TFT LCD Digital Color Monitor (DVI model) Note: Before you attach the DVI monitor, make sure that the computer is attached to the expansion unit and the system works properly. To attach the DVI monitor, do as follows: 1 2 3 4 Turn off the computer. Insert a small flathead screwdriver or a similar tool into the slot at the upper left of the cover on the DVI connector, and pry the cover off. Connect the DVI monitor to the DVI connector on the rear of the expansion unit, and then connect the monitor to an electrical outlet. Turn on the DVI monitor and the computer. USB connector If you are using Windows 95, you can use only the lower USB connector of the ThinkPad Dock docking station. Installing the device driver for Windows NT 4. 0 The updated procedure is as follows: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Turn on the computer. After Windows NT has started, click Start Settings Control Panel. If you find either of the following drivers, remove it. Intel PIIX PCI Bus Master IDE Controller IDE CD-ROM (ATAPI 1. 2)/Dual Channel PCI IDE Controller If you do not find the ThinkPad PIIX4 IDE Driver, install it from the Software Selections CD. Specify the location of the device driver in the Software Selections CD, and click OK. Make sure that CMD PCI-0648 is selected, and click OK. When prompted for the location of the file, specify the location of the device driver in the Software Selections CD. If you are prompted to restart the system, select No. Shut down the system, and turn off the computer. Attach the computer to the ThinkPad Dock. [. . . ] is there, there might be a system resource conflict with the other port. ThinkPad Dock Problem The PC Card, a PCI card, or a device in the Ultrabay 2000 installed in a docking station is not recognized, and the PC Card slots cannot be used. Cause and action Make sure that the power cord is connected to the docking station. Make sure that the docking indicator of the docking station is on. Make sure that the computer is securely attached to the docking station. 15 Notices Notice for Australia The following notice applies when using the telephony functions: WARNING: FOR SAFETY REASONS, ONLY CONNECT EQUIPMENT WITH A TELECOMMUNICATIONS COMPLIANCE LABEL. [. . . ]