User manual SONY VAIO VPC-L22SFX/W

[. . . ] Bluetooth is a trademark owned by its proprietor and used by Hewlett-Packard Company under license. Intel is a trademark or registered trademark of Intel Corporation in the United States and other countries. SD Logo is a trademark of its proprietor. Java is a trademark of Sun Microsystems, Inc. [. . . ] When seated, wear a wrist strap connected to a grounded system. Wrist straps are flexible straps with a minimum of one megohm ±10% resistance in the ground cords. To provide proper ground, wear a strap snugly against the skin at all times. On grounded mats with banana-plug connectors, use alligator clips to connect a wrist strap. When standing, use foot straps and a grounded floor mat. Foot straps (heel, toe, or boot straps) can be used at standing workstations and are compatible with most types of shoes or boots. On conductive floors or dissipative floor mats, use foot straps on both feet with a minimum of one megohm resistance between the operator and ground. To be effective, the conductive strips must be worn in contact with the skin. Other grounding equipment recommended for use in preventing electrostatic damage includes Antistatic tape. Antistatic smocks, aprons, and sleeve protectors. Conductive bins and other assembly or soldering aids. Loosen the Phillips PM2. 5×13. 0 spring-loaded hard drive retention screw 1. Grasp the mylar tab 2 on the hard drive and slide the hard drive 3 to the right to disconnect it from the system board. Remove the hard drive 4 from the hard drive bay. Removing the Hard Drive 5­8 Maintenance and Service Guide Removal and Replacement Procedures 9. Remove the four Phillips PM3. 0×4. 0 hard drive frame screws 1 from each side of the hard drive. Lift the frame 2 straight up to remove if from the hard drive. Removing the Hard Drive Frame Reverse the above procedure to reassemble and install the hard drive. Maintenance and Service Guide 5­9 Removal and Replacement Procedures 5. 5 Computer Feet The computer feet are adhesive-backed rubber pads. The feet are included in the Plastics Kit, spare part number 430884-001. Replacing the Computer Feet 5­10 Maintenance and Service Guide Removal and Replacement Procedures 5. 6 Bluetooth Module Bluetooth Module Spare Part Number Information Bluetooth module (includes Bluetooth module cable) 398393-001 1. Prepare the computer for disassembly (refer to Section 5. 3). Slide the Bluetooth module 1 out of the clip in the hard drive compartment. Disconnect the Bluetooth cable 2 from the module. Removing the Bluetooth Module Reverse the above procedure to install a Bluetooth module. Maintenance and Service Guide 5­11 Removal and Replacement Procedures 5. 7 External Memory Module Memory Module Spare Part Number Information PC2-5300 1024-MB 512-MB 256-MB 414046-001 414045-001 414044-001 1. Prepare the computer for disassembly (refer to Section 5. 3). Position the computer with the front toward you. [. . . ] Remove the screws 2 that secure the LCD panel to the display rear panel. Release the LCD panel 3 from the display rear panel. Release the tape 4 that secures the LCD panel to the display rear panel. Releasing the LCD Panel Maintenance and Service Guide C­13 Display Component Recycling 23. Remove the LCD panel. Removing the LCD Panel 24. [. . . ]