User manual SONY VPL-BW5VPS

[. . . ] 4-118-727-01 (1) Video Projector Operating Instructions VPL-BW5 © 2008 Sony Corporation WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. IMPORTANT The nameplate is located on the bottom. [. . . ] The higher the setting, the sharper the picture. The lower the setting, the softer the picture, thus reducing the noise. Adjusts the response characteristics of the tone of the picture. Select a favorite tone from three options. Gamma1: Makes a scene a little brighter. Middle: Gives a neutral tint between "High" and "Low". According to the film source you have selected, make a setting for playback. Off: Plays a video signal in an interlace format without converting. Progressive: Converts an interlace format video signal to a progressive format. Reproduces the 23 Pull-Down film sources with smooth picture movement. When the video signal with a format other than the 2-3 Pull-Down is input, "Progressive" is automatically selected. Initial setting 50 Color 50 Hue 50 Sharpness 30 Gamma Mode Off Color Temp. Set according to the input signal DDE (Dynamic Detail Enhancer) Film 36 INPUT SETTING Menu The INPUT SETTING menu is used to adjust the input signal. When the signal is input from a computer Adjust Signal. . . Wide Mode: Over Scan: Normal Off Using the Menus Setting items Adjust Signal. . . Dot Phase Functions Adjusts the dot phase of the LCD panel and the signal output from a computer. Adjust the picture further for finer picture after the picture is adjusted by pressing the APA key. Adjusts the horizontal size of a picture output from a computer. Adjust the setting according to the dots of the input signal. (1 page 54) Adjusts the position of the picture. H: As the setting for H (horizontal) increases, the picture moves to the right, and as the setting decreases, the picture moves to the left. Use </, to adjust the horizontal position. V: As the setting for V (vertical) increases, the picture moves up, and as the setting decreases, the picture moves down. Use M/m to adjust the vertical position. [. . . ] 37 Shift . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37 Adjuster . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Adjusting picture position . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 picture quality . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]