User manual SONY VPL-CS3

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. The number below is for FCC related matters only. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Press the M or m key to select "LANGUAGE, " then press the , or ENTER key. Press the M or m key to select a language, then press the < or ENTER key. The menu disappears automatically if a key is not pressed for one minute. Open the front cover, plug the AC power cord into a wall outlet, then connect all equipment. The ON/STANDBY indicator lights in red and the projector goes into standby mode. Turn the zoom lever to adjust the size of the picture. To return the image back to its original size Press the D ZOOM ­ key. Just pressing the RESET key returns the image back to its original size immediately. to freeze the image projected (Freeze function) Press the FREEZE key. "FREEZE" appears when the key is pressed. This function works only when a signal from a computer is input. The projector is equipped with an on-screen menu for making various adjustments and settings. You can change the menu language displayed in the on-screen menu. When changing the adjustment level: To increase the number, press the M or , key. When changing the setting: Press the M or m key to change the setting. The menu disappears automatically if a key is not pressed for one minute. " appears on the screen and the settings appearing on the screen are reset to their factory preset values. Use the M or m key to select a menu, then press the , or ENTER key. About the memory of the settings Use the M or m key to select the item, then press the , or ENTER key. If there is no input signal, "NO INPUT­ Cannot adjust this item. You can set the display position of the menu, intensity of the background picture and tone of the menu items as you like. Items that cannot be adjusted depending on the input signal are not displayed in the menu. [. . . ] ) or near materials (curtains, draperies) that may block the ventilation holes. When the internal heat builds up due to the block-up, the temperature sensor will function with the message "High temp. " The power will be turned off automatically after one minute. Leave space of more than 30 cm (11 7/8 inches) around the unit. [. . . ]