User manual SONY VPL-CS6

[. . . ] In this manual such names are not indicated by ® or TM symbols. This unit is equipped with the network presentation and control function. Any image of a computer, if it is connected to a LAN by wired or wireless connection, can be projected by connecting a network cable to the NETWORK connector (RJ45) of the projector. Operations such as power on/off or input selection of the projector or confirmation of the situation of the projector such as lamp used time is possible far from the projector. [. . . ] When it starts, the [ ] icon appears in the task tray. When [Create Shortcut Icon into Startup Folder. 5 projectors may not be able to be connected at the same time due to the computer. ⷠWhen the projector and a computer that has a different network segment (subnet) are connected, set [PC Registration List] (page 10) on the projector and [Projector Setting] (page 17) on the computer. Press the M or m key on the remote commander to select the computer, and then press the ENTER key. Press the M or m key on the remote commander to select the computer to be connected from the list and then the ENTER key. When the projector and a computer that has a different network segment (subnet) are connected, set [PC Registration List] (page 10) on the projector and [Projector Setting] (page 17) on the computer. External monitor signal of notebook type computer may not be output when you use Projector Station for Air Shot Version 2. When [When a connection/Disconnection request is received] is set to [Always Yes] or [Always No] in the setting of the application software, the connection confirmation message does not appear and the application software always permits/ refuses connection/disconnection. Press the M or m key on the remote commander to select the connecting computer from the list, then press the ENTER key. When the projector and a computer that has a different network segment (subnet) are connected, set [PC Registration List] (page 10) on the projector and [Projector Setting] (page 17) on the computer. To use the Simple Mode in this version of Projector Station for Air Shot Version 2, check the check box of [Enable Air Shot V2 Version 1. Do not check when only the VPL-CX155/ CX125 series model is used. 0 or higher) and enter the address "http://xxx. If the browser of your computer is set to "Access the Internet using a proxy server, " enter the IP address of the projector in the box "Access the Internet without using a proxy server" when you have access to the projector from your computer. After access, the following display appears. You can switch the mode and set each mode. To set each mode, select the desired mode button and then click [Setup] to display the Setup display of the mode. This information is used for the Mail Report function. Click [Apply] in the lower part of each window to update the projector to the data input in each window. Time Zone Select the region in which you are using the projector. Time Server Enter the address of the time server when the time is set by a timer server. [. . . ] C After the projector operations are complete, communicate it and turn it off again. C Close the [Setting] window and then communicate it and turn it off again. ⷠThe computer you are trying to communicate is performing turning on/off operations. C After the computer operations are complete, communicate it and turn it off again. [. . . ]