User manual SONY VPL-CS7

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Caution use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. [. . . ] Install the two size AA (R6) batteries (supplied) with the correct polarity. Be sure to install the battery from the ' side. Make sure that the battery orientation is correct when inserting batteries. Do not mix an old battery with a new one, or different types of batteries. If you will not use the Remote Commander for a long time, remove the batteries to avoid damage from battery leakage. If batteries have leaked, remove them, wipe the battery compartment dry and replace the batteries with new ones. notes on Remote Commander operation · Make sure that there is nothing to obstruct the infrared beam between the Remote Commander and the remote control detector on the projector. The shorter the distance between the Remote Commander and the projector is, the wider the angle within which the commander can control the projector. The distance between the lens and the screen varies depending on the size of the screen. When the VGA signal is input, the picture size becomes smaller by 20%. When the Macintosh 16-inch mode (832 × 624) signal is input, the outer image (32 dots (horizontal) /24 lines (vertical)) is not displayed. " appears on the screen, and each item cannot be adjusted. The lower the setting, the lower the contrast. Select an item Use the V or v key to select the item, then press the b or ENTER key. When changing the adjustment level: To increase the number, press the V or b key. When changing the setting: Press the V or v key to change the setting. The lower the setting, the lower the intensity. A higher the setting, the picture becomes greenish. A lower the setting, the picture becomes purplish. OFF: Reproduces the dark portions of the picture accurately, in accordance with the source signal. If the picture is distorted or colorless, select the color system according to the input signal. Adjust the picture to where it looks clearest. [. . . ] Either the picture or the sound is cut off. Noise may appear on the background depending on the combination of the numbers of dot input from the connector and numbers of pixel on the LCD panel. Remedy Wait for about 90 seconds before turning on the power (see page 21 (EN)). Close the lamp cover securely (see page 33 (EN)). [. . . ]