User manual SONY VPL-CX5

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. The number below is for FCC related matters only. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] For details on the TILT adjustment key, see "How to use the powered tilt adjuster" on page 11. When you adjust the powered tilt adjuster with the TILT key, the automatic keystone adjustment is performed at the same time. If you do not want to perform the automatic keystone adjustment, set the V Keystone menu to "Manual. Turn the zoom ring to adjust the size of the picture. The auto keystone adjustment may not correct the trapezoidal distortion perfectly, depending on the room temperature or the screen angle. Press the KEYSTONE key on the Remote Commander until "V Keystone" appears on the screen, and adjust the value with the M/m/</, key. The corrected value is effective until the power turn off. Looking into the lens when projecting may cause injury to your eyes. To switch from the Intelligent Auto-setup function to manual adjustments You can switch the following functions of the Intelligent Auto-setup to manual adjustments using the menu. To mute the picture temporarily Press the PIC MUTING key on the Remote Commander. To control the computer using the supplied Remote Commander When you connect an IBM PC/AT compatible computer to the projector by using the USB cable, you can control the mouse of the computer using the Remote Commander. the R/L CLICK keys and joystick function as follows. Key and joystick R CLICK (front) L CLICK (rear) Joystick Function Right button Left button Corresponds with the movements of the mouse Make sure that nothing obstructs the infrared beam between the Remote Commander and the remote control detector on the projector. To turn off the power " appears to confirm that you want to turn off the power. A message disappears if you press any key except the I / 1 key, or if you do not press any key for five seconds. The ON/STANDBY indicator flashes in green and the fan continues to run for about 90 seconds to reduce the internal heat. Also, the ON/STANDBY indicator flashes quickly for the first 60 seconds. During this time, you will not be able to light up again the ON/STANDBY indicator with the I / 1 key. Unplug the AC power cord from the wall outlet after the fan stops running and the ON/STANDBY indicator lights in red. When you cannot confirm the on-screen message in a certain condition, you can turn off the power by holding the I / 1 key for about two seconds. Do not unplug the AC power cord while the fan is still running; otherwise, the fan will stop even though the internal heat is still high, which could result in a breakdown of the projector. On air filter To maintain optimal performance, clean the air filter every 300 hours. [. . . ] C Check that the proper connections have been made (see page 17). C Replace with a new battery (see page 15). The lamp cover or the air filter cover is detached. C Wait for 90 seconds to cool down the lamp and turn on the power again (see page 26). [. . . ]