User manual SONY VPL-CX63

[. . . ] To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. When installing the unit, incorporate a readily accessible disconnect device in the fixed wiring, or connect the power cord to socket-outlet which must be provided near the unit and easily accessible. If a fault should occur during operation of the unit, operate the disconnect device to switch the power supply off, or disconnect the power cord. Dispose of used batteries according to the manufacturer's instructions. [. . . ] Turn the main power off and disconnect the AC power cord. The security lock is set to on, then it becomes effective. The screen used for entering the password is displayed when the power is turned on the next time. Security certification When the password screen is displayed, enter the password that was set. If you fail to enter the correct password after three tries, the projector cannot be used. You can switch the following auto adjustments functions to manual adjustments using the menu. Press the MENU key, then turn off the "Security Lock" setting on the INSTALL SETTING menu. If you call the customer service center because you have forgotten the password, you will need to be able to verify the projector's serial number and your identity. (This process may differ in other countries/regions. ) Once your identity has been confirmed, we will provide you with the password. The cooling fan runs for a certain time automatically even after the power is turned off and the power cord is disconnected. This enables you to move the projector from the conference room to another location immediately after turning it off. If you will be using a circuit breaker to turn the power for the entire system on and off, set the direct power on function to "On. " When you turn off the power, you can also just unplug the power cord without pressing the ?The internal circuitry will cause the fan to automatically operate for a certain time even after the power cord is removed. However, if the unit has been on for less than 15 minutes, the fan might not begin to turn as a result of inadequate charging. In that case, follow the procedure for turning off the power as described in "Turning Off the Power" on page 19. This function works when a signal from a computer is input. This function does not work when a video signal is input. To return the image to its original size Press the D ZOOM ­ key. Just pressing the RESET key returns the image back to its original size immediately. "Freeze" appears when the key is pressed. [. . . ] Use the list below to check the meaning of the messages displayed on the screen. Meaning and Remedy You have pressed the wrong key. " c All the keys on the control panel of the projector are locked. Operate the projector with the keys on the Remote Commander (see page 30). [. . . ]