User manual SONY VPL-CX75

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Telephone Number: 858-942-2230 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] You can select one of fifteen languages for displaying the menu and other on-screen displays. Press the M or m key to select the MENU SETTING menu, then press the , or ENTER key. Press the M or m key to select "Language, " then press the , or ENTER key. Plug the AC power cord into a wall outlet. Press the I / 1 key to turn on the projector. Press the M, m, < or , key to select a language, then press the ENTER key. The menu disappears automatically if a key is not pressed for one minute. The projector is equipped with a security lock function. When you turn the power of the projector on, you are required to input the previously set password. If you do not input the correct password, you will not be able to project the picture. Next, the screen for entering the new password is displayed. (Enter the password at this screen even if you want to keep the current password. Power-on cannot be performed without the password. You will not be able to use the projector if you forget your password and the password administrator is not available. Be please aware that using the security lock can prevent valid usage in such cases. To use the security lock Press the MENU key and then, in the INSTALL SETTING menu, turn on the "Security Lock" setting. Use the MENU, </, /M/m, and ENTER keys to enter the four-digit password. (The default initial password setting is "ENTER , ENTER , ENTER , ENTER. " After this is entered you can put in your own password. Therefore when you use this function for the first time, please input "ENTER" four times. When the following message is displayed, the setting for security lock is completed. Turn the main power off and disconnect the AC power cord. [. . . ] Operate the projector with the keys on the Remote Commander (see page 36). 78 Lamp 165 W UHP Projection picture size 40 to 300 inches (measured diagonally) Light output ANSI lumen1) 2500 lm (VPLCX75) ANSI lumen1) 2000 lm (VPLCX70) (When the Lamp Mode is set to "High") Throwing distance (When placing on the floor) When the XGA signal is input 40-inch: 1. 1 feet) There may be a slight difference between the actual value and the design value shown above. 43 is the color system used when playing back a video recorded on NTSC on a NTSC4. [. . . ]