User manual SONY VPL-EX1

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. The number below is for FCC related matters only. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] The corrected value is effective until the power turn off. Looking into the lens when projecting may cause injury to your eyes. To switch from the Intelligent Auto-setup function to manual adjustments You can switch the following functions of the Intelligent Auto-setup to manual adjustments using the menu. To mute the picture temporarily (VPL-CS6/CX6 only) Press the PIC MUTING key on the Remote Commander. To control the computer using the supplied Remote Commander When you connect an IBM PC/AT compatible computer to the projector by using the USB cable, you can control the mouse of the computer using the Remote Commander. the R/L CLICK keys and joystick function as follows. Key and joystick R CLICK (front) L CLICK (rear) Joystick Function Right button Left button Corresponds with the movements of the mouse Make sure that nothing obstructs the infrared beam between the Remote Commander and the remote control detector on the projector. Press the MENU key and then, in the INSTALL SETTING menu, turn on the "Security Lock" setting. Use the MENU, M/m/</, , and ENTER keys to enter the four-digit password. (The default initial password setting is "ENTER , ENTER , ENTER , ENTER". After this is entered you can put in your own password. Therefore when you use this function for the first time, please input "ENTER" four times. Next, the screen for entering the new password is displayed. (Enter the password at this screen even if you want to keep the current password. Power-on cannot be performed without the password. Turn the main power off and disconnect the AC power cord. The security lock is set to on, then it becomes effective. The screen for entering the password is displayed when the power is turned on the next time. You will not be able to use the projector if you forget your password and the password administrator is not available. Be please aware that using the security lock can prevent valid usage in such cases. If you fail to enter the correct password after three tries, the projector cannot be used. In this case, press the I / 1 key to turn off the power. [. . . ] Perform this procedure only in an emergency case. You cannot recover the powered function yourself if you perform this procedure. After you use the projector in the emergency mode, consult with qualified Sony personnel immediately. To switch to the emergency mode, follow the steps below. [. . . ]