User manual SONY VPL-FX50

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. For the customers in the USA This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] Press the FOCUS key then the M or m key on the Remote Commander to adjust the focus. Press the ZOOM key then the M or m key on the Remote Commander to adjust the picture size. Press the FOCUS key and arrow keys on the Remote Commander to adjust the focus again. Press the SHIFT key then the M or m key on the Remote Commander to adjust the vertical position of the picture. Adjust the signal when the still picture is displayed on the screen. If there are black edges around the image, the APA function will not function properly and the image may extend beyond the screen. If you switch the input signal or re-connect a computer, press the APA key again to get the suitable picture. " appears on the screen when the picture is adjusted properly. The picture may not be adjusted properly depending on the kinds of input signals. Adjust the items in the INPUT SETTING menu when you adjust the picture manually. When the projecting image is a trapezoid, perform the shift adjustment with the SHIFT key. if the image is still a trapezoid , correct it in DIGIT KEYSTONE in the INSTALL SETTING menu. When the base edge is longer than the upper edge as shown in the figure below: To use the keys on the control panel for focus, zoom and shift adjustments Press the LENS CONTROL key repeatedly to display the adjustment mode you want. Each press changes the mode, "LENS FOCUS, " "LENS ZOOM" and "LENS SHIFT" in this order. When the upper edge is longer than the base edge as shown in the figure below: Looking into the lens when projecting may cause injury to your eyes. Cut off the picture press the PIC MUTING key on the Remote Commander. To restore the picture, press the PIC MUTING key again. To turn off the power The message will disappear if you press any key except the I / 1 key, or if you do not press any key for five seconds. The ON/STANDBY indicator flashes in green and the fan continues to run for about 120 seconds to reduce the internal heat. Also, the ON/STANDBY indicator flashes quickly for the first 40 seconds. During this time, you will not be able to turn the power back on with the I / 1 key. Move the icon to the point on the image you want to enlarge. [. . . ] Select the input source correctly using the INPUT key (see page 18 (GB)). Press the PIC MUTING key to release the muting function (see page 19 (GB)). The picture from INPUT B connector is not projected. Make connections using the proper procedures (see page 15 (GB)). [. . . ]