User manual SONY VPL-FX51

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. For the customers in the USA This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] " Then press the arrow keys to adjust. Press the LNES key on the Remote Commander or LENS CONTROL key on the control panel repeatedly to display "LENS ZOOM. " Then press the arrow keys to adjust. Press the LNES key on the Remote Commander or LENS CONTROL key on the control panel repeatedly to display "LENS FOCUS. " Then press the arrow keys to adjust again. Press the LNES key on the Remote Commander or LENS CONTROL key on the control panel repeatedly to display "LENS SHIFT. Adjust the signal when the still picture is displayed on the screen. If there are black edges around the image, the APA function will not function properly and the image may extend beyond the screen. If you switch the input signal or re-connect a computer, press the APA key again to get the suitable picture. " appears on the screen when the picture is adjusted properly. The picture may not be adjusted properly depending on the kinds of input signals. Adjust the items in the INPUT SETTING menu when you adjust the picture manually. When the projecting image is a trapezoid, press the LNES key on the Remote Commander or LENS CONTROL key on the control panel repeatedly to display "LENS SHIFT. When the base edge is longer than the upper edge as shown in the figure below: Looking into the lens when projecting may cause injury to your eyes. When the upper edge is longer than the base edge as shown in the figure below: Cut off the picture press the PIC MUTING key on the Remote Commander. To restore the picture, press the PIC MUTING key again. To get the clearest picture You can get the suitable picture when a signal from the computer is input. To turn off the power The message will disappear if you press any key except the I / 1 key, or if you do not press any key for five seconds. The ON/STANDBY indicator flashes in green and the fan continues to run for about 120 seconds to reduce the internal heat. Also, the ON/STANDBY indicator flashes quickly for the first 40 seconds. During this time, you will not be able to turn the power back on with the I / 1 key. Move the icon to the point on the image you want to enlarge. [. . . ] The picture from INPUT B connector is not projected. Make connections using the proper procedures (see page 15 (GB)). In the INSTALL SETTING menu to OFF, then set it to ON again (see page 27 (GB)). The digital picture from INPUT The connecting procedures are wrong. [. . . ]