User manual SONY VPL-HW10

[. . . ] 3-876-649-15 (1) Video Projector Operating Instructions VPL-HW10 © 2008 Sony Corporation WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. THIS APPARATUS MUST BE EARTHED. Declaration of Conformity Trade Name: SONY Model No. : VPL-HW10 Responsible Party: Sony Electronics Inc. [. . . ] Zoom: A 16:9 aspect ratio picture is enlarged vertically and horizontally in the same ratio to fill the screen. You can switch settings by pressing WIDE MODE on the remote control. Wide Mode (Computer signal) 45 Over Scan Hides the outline of the picture. On: Hides the outline of the input picture. Select this setting when noise appears along the edge of the picture. Off: Projects the whole of the input picture. Tip To display the displayable region within the four directions of the screen, refer to "Blanking" on the Installation menu (1 page 50). Screen Area Selects the size of the picture when a Hi-Vision picture is overscanned. Full: Expands the picture on the whole of the screen. Through: Does not expands the picture on the whole of the screen. Adjust the whole picture by moving up and down on the screen. As the selected number increases, the screen moves up, and as the selected number decreases, the screen moves down. Reduces or enlarges the picture vertically. The screen is enlarged as the setting increases and reduced as the setting decreases. cannot be seen, use this together with "V Center". APA: Adjusts "Phase", "Pitch", and "Shift" automatically to a position that suits the image signal for pictures from a computer. You can make adjustments by pressing APA on the remote control. Phase: Adjusts the dot phase and the phase of computer signal of pictures from a computer. Adjusts the picture to the point where it looks clearest. Pitch: Adjusts the horizontal size of the picture from a computer. As the number increases, the picture becomes wider, and as the number decreases, the picture becomes narrower. Adjust the setting to match the number of dots of the input signal. Shift: Adjusts the position of the picture. H: As the setting for H (horizontal) increases, the picture moves to the right, and as the setting decreases, the picture moves to the left. [. . . ] 53 Preset Signals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 66 R RCP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44 Remote control inserting the batteries . . . . . . . . . . . . . . . . . . . . . . . . . . 11 location of controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]