User manual SONY VPL-HW20A

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. [. . . ] 3 Unplug the AC power cord from the wall outlet after the fan stops running and the ON/STANDBY indicator lights in red. You can turn off the projector by holding the [/1 (on/ standby) switch for about one second, instead of performing the above steps. Each time you press the button, you can select the "Wide Mode" setting. Full A 16:9 squeezed picture is displayed with the correct aspect ratio. A 4:3 picture is enlarged horizontally to fit the 16:9 screen. Subtitle The subtitle area is compressed and displayed in the lower part of the screen. Use this mode to view a movie with subtitles. Normal A picture with normal 4:3 aspect ratio is displayed in the center of the screen to fill the vertical screen size. The projector is equipped with an on-screen menu for making various adjustments and settings. the setting items are displayed in a pop-up menu or in a sub menu. If you select an item name followed by dots (. You can also adjust the picture quality in "Dynamic", "Standard" or "Cinema" mode. High: Gives the white colors a blue tint. Reproduces the 2-3 Pull-Down film sources with smooth picture movement. When the video signal with a format other than the 2-3 Pull-Down is input, "Progressive" is automatically selected. Tip If "Cinema Black" is set to "On, " the next time the power is turned on, the lamp will use the "Off" setting for the first time, and then go to "On. Description You can select the 4:3 aspect ratio picture mode, "Normal" and "Normal Through, " and 16:9 aspect ratio picture mode, "Full, " "Wide Zoom, " "Zoom, " "Subtitle" and "Full Through. " Full: The 16:9 squeezed* picture is diplayed with the correct aspect. The 4:3 picture is enlarged horizontally to fit the 16:9 screen. * squeezed: An original 16:9 aspect ratio picture is recorded horizontally compressed to be a 4:3 picture. Normal: The picture with normal 4:3 aspect ratio is displayed to fill the vertical screen size. Wide Zoom: The picture with 4:3 aspect ratio is enlarged and the upper and lower portions of the picture are compressed to fit the 16:9 screen. [. . . ] 4 Insert the new lamp all the way in until it is securely in place. Tighten the screw, and fold down the handle. 6 While pushing the projector cover toward you by holding both sides of the cover on the lens side, close the cover until it clicks. When the replacement message appears on the screen, replace the air filter without delay. [. . . ]