User manual SONY VPL-PX1

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. For the customers in the USA This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] 1) When both the S VIDEO and VIDEO jacks are connected to the external equipment, the input signal from the S VIDEO jack is selected. (If you connect to both the S VIDEO and VIDEO jacks, the signal from the S VIDEO jack is selected. Turn the zoom ring to adjust the size of the picture. Looking into the lens when projecting may cause injury to your eyes. To Adjust the volume Cut off the sound To restore the sound, press the AUDIO MUTING key again or press the VOLUME + key. the PICTURE MUTING key on the Remote Commander. To restore the picture, press the PICTURE MUTING key again. Cut off the picture To get the clearest picture You can get the suitable picture when a signal from the computer is input. After all equipment is connected completely, plug the AC power cord into the wall outlet. The ON/STANDBY indicator lights in red and the projector goes into the standby mode. Adjust the signal when the still picture is displayed on the screen. If you switch the input signal or re-connect a computer, press the APA key again to get the suitable picture. " appears on the screen when the picture is adjusted properly. The picture may not be adjusted properly depending on the kinds of input signals. Adjust DOT PHASE in the INPUT SETTING menu when you adjust the picture manually. To turn off the power The following message appears to confirm if you want to turn off the power. The message will disappear if you press any key except the I / 1 key, or if you do not press any key for five seconds. The ON/STANDBY indicator flashes in green and the fan continues to run for about 90 seconds to reduce the internal heat. Also, the ON/STANDBY indicator flashes quickly for the first 30 seconds. During this time, you will not be able to turn the power back on with the I / 1 key. Unplug the AC power cord from the wall outlet after the fan stops running and the ON/STANDBY indicator lights in red. When you cannot confirm the on-screen message When you cannot confirm the on-screen message in a certain condition, you can turn off the power by holding the I / 1 key on the Remote Commander or on the control panel for about one second. [. . . ] Do not install the projector in the following situations. These installations may cause malfunction or damage to the projector. Avoid installing the unit in a location where there is a lot of dust; otherwise, the air filter will be obstructed. The dust blocking the air through the filter may cause raising the internal heat of the projector. [. . . ]