User manual SONY VPL-PX11

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. For the customers in the United Kingdom WARNING THIS APPARATUS MUST BE EARTHED IMPORTANT The wires in this mains lead are coloured in accordance with the following code: Green-and-Yellow: Earth Blue: Neutral Brown: Live As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol I or coloured green or green-and-yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. [. . . ] " appears on the screen when the picture is adjusted properly. However, depending on the kinds of input signal, the picture may not always be adjusted properly. Adjust the items in the INPUT SETTING menu when you adjust the picture manually. The message will disappear if you press any key except the I / 1 key, or if you do not press any key for five seconds. The ON/STANDBY indicator flashes in green and the fan continues to run for about 90 seconds to reduce internal heat build-up. Also, the ON/ STANDBY indicator flashes quickly for the first 60 seconds. During this first 60 seconds, you will not be able to turn the power back on with the I / 1 key. Unplug the AC power cord from the wall outlet after the ON/STANDBY indicator lights in red. The built-in circuits provided for carrying out the Off & Go function (page 8 (GB)) may keep the cooling fan running for a while after the ON/ STANDBY indicator turns from green to red just after you turn off the projector by pressing the I / 1 key. When you cannot confirm the on-screen message When you cannot confirm the on-screen message at anytime, you can turn off the power by holding the I / 1 key for about one second. When you want to turn off the projector quickly You can also disconnect the power cord without pressing I / 1 key. The cooling fan keeps running automatically due to built-in circuits for a certain period of time even though you unplug the power cord (Off & Go function). However, if the projector has not been turned on for a long enough time, the cooling fan may not turn since the projector's condenser has not sufficiently charged. If you do not use the Off & Go function Unplug the AC power cord according to the procedure described in "To turn off the power. When the projected image is a trapezoid, correct it by pressing the D KEYSTONE key on the Remote Commander or by adjusting DIGIT KEYSTONE in the INSTALL SETTING menu. When the base edge is longer than the upper edge as shown in the figure below: When the upper edge is longer than the base edge as shown in the figure below: Clean the air filter every 300 hours to ensure optimal performance. By pressing the + key repeatedly, the image size increases (maximum magnification: 4 times) . You can enlarge an area on the image you select. This function works only when a signal from a computer is input. Project the original size picture and press the D ZOOM + key on the Remote Commander. Use the arrow keys (M/m/</, ) to scroll the enlarged image. Move the icon to a point in the center of the portion of the image you want to enlarge. [. . . ] If you encounter a problem during operation, press the HELP key to display the help messages. You can get these kinds of help messages: · If you still have a problem after consulting the help messages, please check the following. Cause Remedy The power has been turned off and on Wait for about 90 seconds before turning on the with the I / 1 key at too short an interval. Close the lamp cover securely (see page 32 (GB)). [. . . ]