User manual SONY VPL-PX15

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. For the customers in the USA This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] Using a wireless LAN PC card or a 10BASE-T/100BASE-TX LAN cable, you can connect the projector to a wireless or wired LAN. This section describes how to connect to a LAN and how to install a PC card. Whenever you connect the projector to a LAN or use a memory card, set INPUT-B FUNC. When you use a wireless LAN PC card or memory card, insert the card into the INPUT B PC CARD slot. The eject button pops out when the card is inserted. Set the aspect ratio using ASPECT in the INPUT SETTING menu according to the input signal. When you connect the projector to 15k RGB/ component video equipment, select RGB, component or VCR GBR with the INPUT-A setting in the SET SETTING menu. Use the composite sync signal when you input the external sync signal from 15k RGB/component equipment. Connection using a wireless LAN PC card Connection using a wireless LAN PC card (Peer to Peer mode) When you use a LAN, you must set the IP address. For details on how to set the IP address, etc. You can select the language to be used in the menu and other on screen displays from 9 languages. Plug the AC power cord into the wall outlet. Press the I / 1 key to turn on the power. Press the M or m key to select the SET SETTING menu, then press the , or ENTER key. If you store a file created with Microsoft PowerPoint1) in a memory card and insert it into the INPUT B PC CARD slot, you can run a presentation without connecting a computer. Press the M or m key to select LANGUAGE, then press the , or ENTER key. Press the M or m key to select a language, then press the < or ENTER key. After all equipment is connected completely, plug the AC power cord into the wall outlet. The ON/STANDBY indicator lights in red and the projector goes into the standby mode. Press the I / 1 key to turn on the projector. Turn the zoom ring to adjust the size of the picture. Looking into the lens when the projector is projecting an image may cause injury to your eyes. [. . . ] Noise may appear on the background depending on the combination of the numbers of dot input from the connector and numbers of pixels on the LCD panel. sTATUS in the SET SETTING menu has been set to OFF. There is something wrong with the network software. In the INSTALL SETTING menu to OFF, then set it to ON again (see page 33 (GB)). [. . . ]