User manual SONY VPL-PX30

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. For the customers in the USA This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] Select the language desired with the M or m key, then press the < or ENTER key. The menu changes into the selected language . The AUDIO (VIDEO IN) jacks are used as audio outputs of both VIDEO and S-VIDEO. Turn the zoom ring to adjust the size of the picture. Looking into the lens when projecting may cause injury to your eyes. The VOL +/­ keys on the control panel or the VOLUME +/­ keys on the Remoter Commander. the AUDIO MUTING key on the Remote Commander. To restore the sound, press the AUDIO MUTING key again or press the VOL + key on the control panel or the VOLUME + key on the Remote Commander. the PIC MUTING key on the Remote Commander. To restore the picture, press the PIC MUTING key again. Cut off the sound Cut off the picture To get the clearest picture You can get the suitable picture when a signal from the computer is input. After all equipment is connected completely, plug the AC power cord into the wall outlet. The ON/STANDBY indicator lights in red and the projector goes into the standby mode. Adjust the signal when the still picture is displayed on the screen. If there are black edges around the image, the APA function will not function properly and the image may extend beyond the screen. If you switch the input signal or re-connect a computer, press the APA key again to get the suitable picture. " appears on the screen when the picture is adjusted properly. The picture may not be adjusted properly depending on the kinds of input signals. Adjust the items in the INPUT SETTING menu when you adjust the picture manually. To turn off the power The message will disappear if you press any key except the I / 1 key, or if you do not press any key for five seconds. When the projecting image is a trapezoid, change the projector's position/height by moving the adjuster. The ON/STANDBY indicator flashes in green and the fan continues to run for about 120 seconds to reduce the internal heat. [. . . ] sTATUS in the SET SETTING menu has been set to OFF. Remedy Check that the proper connections have been made (see pages 15 (GB) to 18 (GB)). Select the input source correctly using the INPUT key (see page 19 (GB)). Press the PIC MUTING key to release the muting function (see page 19 (GB)). [. . . ]