User manual SONY VPL-PX35

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. For the customers in the USA This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] Enter password key Enter the password again to confirm. Turn the main power off and disconnect the AC power cord. The security lock is set to on, then it becomes effective. The screen for entering the password is displayed when the power is turned on the next time. You will not be able to use the projector if you forget your password and the password administrator is not available. Be please aware that using the security lock can prevent valid usage in such cases. Once the security lock is set and the main power is turned off, the screen for entering the password is displayed when the power is turned on the next time. If you fail to enter the correct password after three tries, the projector cannot be used. In this case, press the I / 1 key to turn off the power. The security lock will not be set if the correct password is not entered in steps 2 and 3, or a key other than the MENU, arrow keys, and ENTER key is pressed. If you call the customer service center because you have forgotten the password, you will need to be able to verify the projector's serial number and your identity. (This process may differ in other countries. ) Once your identity has been confirmed, we will provide you with the password. To turn off the power " appears to confirm that you want to turn off the power. A message disappears if you press any key except the I / 1 key, or if you do not press any key for five seconds. The ON/STANDBY indicator flashes in green and the fan continues to run for about 90 seconds to reduce the internal heat. Also, the ON/STANDBY indicator flashes quickly for the first 60 seconds. During this time, you will not be able to light up the ON/STANDBY indicator with the I / 1 key. Unplug the AC power cord from the wall outlet after the fan stops running and the ON/STANDBY indicator lights in red. When you cannot confirm the on-screen message in a certain condition, you can turn off the power by holding the I / 1 key for about one second. The internal circuitry of the Direct Power On/Off function may cause the fan to continue to operate for a short time even after the I / 1 key is pressed to turn off the power and the ON/STANDBY indicator changes to red. If you will be using a circuit breaker to turn the power for the entire system on and off, set the direct power on function to "On". [. . . ] C Replace with a new battery (see page 16). Press the MENU key on the c Set the PJ/NETWORK select switch to PJ, then press the Remote Commander. The lamp cover or the air filter cover is detached. C Wait for 90 seconds to cool down the lamp and turn on the power again (see page 28). [. . . ]